Kenmore Washer Not Spinning

I have a 110 series Kenmore washer. It will not spin. It has been suggested to check the pump. How do I get to it?

By Steve from Minneapolis

Answers:

Kenmore Washer Not Spinning

Take the two screws out under the end caps on the control panel, flip the control panel back towards the wall, you will see two golden color spring clips on each side, use a screw driver and push down and towards you, also disconnect the molex plug, after that pull the whole case at you. Look at the lid switch that will stop it from spinning, the pump can be bad or the coupler that sits between the motor and tranny.

Ad

Most of the time it will be the lid switch or the actuator that is on the lid. You can put it into spin and open the lid and use something to push down the switch if you don't here a click it will be the switch. You will need the full model# to get the right switch or just take it to your parts store. (06/02/2010)

By tech2

Comments

Add your voice! Click below to comment. ThriftyFun is powered by your wisdom!

Related
In This Article
Washer Not Spinning
Kenmore Washer Not Spinning
Categories
August 29, 2010
Guides
washing machine
Washer Not Spinning Properly
A repairman looking at a washing machine.
Repairing a Washer That Won't Drain or Spin
Front Loading Washer
Front Loading Washer Not Spinning
Windshield wiper tip on windshield
Homemade Windshield Washer Fluid
More
🎉
New Years Ideas!
🎄
Christmas Ideas!
Facebook
Pinterest
YouTube
Contests!
Newsletters
Ask a Question
Share a Post
You are viewing the desktop version of this page: View Mobile Site
© 1997-2016 by Cumuli, Inc. All Rights Reserved. Published by . Page generated on December 1, 2016 at 9:51:34 PM on 10.0.1.22 in 1 seconds. Use of this web site constitutes acceptance of ThriftyFun's Disclaimer and Privacy Policy. If you have any problems or suggestions feel free to Contact Us.
Loading Something Awesome!