social

Starting a Rose Bush from a Cutting

Starting a Rose Bush from a Cutting

How do you start a rose bush form a cutting? Tips from the ThriftyFun community.

Cover Cutting With A Jar

My Mammaw used to take a cutting and just ram it in the ground where she wanted it to grow and would place a quart jar over it and leave it there until new growth begins. She would have some fail, but not too often.

Advertisement

Her thumb was greener than green. She always lived in East TX, but I'm sure no matter where you are, if the cutting is getting plenty of sun, and the soil is moist to begin with, it should take root.

I do not believe roses will root in water alone though. Here is a site you might enjoy:

By Tina Brown

My mom could start rosebushes from cuttings, though I never tried, her's sure grew! Be sure to get a cutting with a bloom and five leaf fronds. Plant three fronds, leaving two above ground, pinch off the bloom and cover with a glass jar until new growth. Very similar to the previous post, just be sure of the bloom part if you want to be sure of the bush also blooming.

By Margie

Plant With A Bean

I have always used a cutting to transplant roses and the way I do it is to get a cutting just under the joint and slit it and then put a pinto or some kind of bean and dip it in Rootone and plant. I always said a verse, "If you grow, you grow. If you don't, out you go" and it did grow. The bean is what takes root first and it helps to give the twig a chance to take root.

Advertisement


By Margaret from TX

Coffee Can

I was taught to take the cutting, dip it in rooting hormone, and plant in a coffee can filled 3/4 way with damp sand (you can do several at once in the same can). Cover with the lid and wait until rooted. Just make sure you don't bake the cuttings in a hot place. Not sure if this would work as well with the newer plastic cans.

By susan

Just Stick It In The Ground

I picked a beautiful rose at my Mom's house and stuck it in the ground in my yard a few years ago and now I have one of the most beautiful rose bushes any where! Just cut you a piece of the bush off at a joint and put it in some good soil.

By Shelly

Answers:

Starting a Rose Bush from a Cutting

In October you can take cuttings 12 inches long, strip off leaves on the bottom 6 inches of the cuttings , put that 6 inches in the ground, then remove the next set of leaves. You can also use Rootone on the cuttings. Just dip the tip in water then in Rootone. Cover with any kind of jar that is tall enough to cover it. Leave jar on till spring, then you should have new plants. You will be able to see the new growth through the jar. Good luck. Enjoy (07/23/2008)

Advertisement


By betty green

Starting a Rose Bush from a Cutting

It is illegal to propagate patented roses. (12/01/2008)

By John L.

Add your voice! Click below to comment. ThriftyFun is powered by your wisdom!

 
In This Page
Categories
May 15, 2009
Pages
More
🍀
St. Patrick's Ideas!
🌻
Gardening
🐰
Easter Ideas!
Facebook
Pinterest
YouTube
Instagram
Categories
Better LivingBudget & FinanceBusiness and LegalComputersConsumer AdviceCoronavirusCraftsEducationEntertainmentFood and RecipesHealth & BeautyHolidays and PartiesHome and GardenMake Your OwnOrganizingParentingPetsPhotosTravel and RecreationWeddings
Published by ThriftyFun.
Desktop Page | View Mobile
Disclaimer | Privacy Policy | Contact Us
Generated 2024-03-10 14:20:10 in 9 secs. ⛅️️
© 1997-2024 by Cumuli, Inc. All Rights Reserved.
https://www.thriftyfun.com/Starting-a-Rose-Bush-from-a-Cutting-1.html