| ||
| Source: http://www.thriftyfun.com/tf25096185.tip.html | ||
Bandana Bonnets
Approximate Time Less than 1hr Supplies:
Instructions:Step 1: Iron Bandana to get out all store wrinkles. (You can also wash and dry to get out all the starchy stiffness if you desire)Step 2: Open Bandana up wrong side facing up. Fold one edge toward the middle 6inches. Bring other edge to meet it. Iron in new creases. Step 3: Apply fuseable web to the back of your ribbon Step 4: Center Ribbon over seam where the two edges meet. Iron ribbon into place over the seam. Be sure to follow factory directions for your fuseable web. The smaller of the two sides is the front of the bonnet and the larger is the back of the bonnet.
Step 5. You are now going to make the casing for the elastic at the back. You will sew a straight line from one edge to the other about 1/2 and inch from the fold. At this time you can also use the machine to add a decorative stitch to your ribbon or you can hand embroider over the ribbon to make it more secure.
Step 6: And here is where it gets a bit tricky. Thread your 3 inches of ribbon into the casing. Gathering as evenly as you can. Secure your elastic together by sewing over the two ends a few times. Release the elastic and with needle and thread close the gap that remains over the elastic. Finished! By Hanane from Garland, TX | ||
| Source: http://www.thriftyfun.com/tf25096185.tip.html | ||
|
© 1997-2009 ThriftyFun.com
Disclaimer: ThriftyFun.com cannot accept any responsibility for any injury or damage that you may cause to yourself, others, or property when following any advice given on this site. Read the full disclaimer: http://www.thriftyfun.comdisclaimer.ldml If you find any information on ThriftyFun.com or in our newsletters that is either erroneous and/or potentially harmful to others, please Contact Us, immediately. |