Craft Project: 3-D Easter Bunny Card
|
Approximate Time: About 30 minutes
Supplies:
- Green,yellow and white card stock
- pink craft foam
- Six 4-inch lengths of thin wire
- wiggly eyes
- pencil
- scissors
- glue stick
- powder blush and cotton swab
- hot glue gun & glue sticks
Instructions:
Fold a piece of 8 1/2 x 11-inch green card stock in half to form a card. Cut an 8 1/4 x 5 1/4-inch rectangle from yellow card stock. Glue the rectangle to the front of the card. Draw a cute bunny onto the white card stock and cut out. Draw a large pink nose onto the pink foam and cut out. Using a cotton swab and powdered blush, apply blush to lower edge of ears to represent the bunny's inner ears. Glue the bunny head to the rectangle. Glue on the wiggly eyes. For the whiskers, curl each piece of wire around a pencil and flatten slightly with your hand. Using hot glue gun, glue ends of wire just below wiggly eyes. Glue foam nose over wire ends. Write an Easter message inside the card and send to someone special.By Rachel's Mom from Wilkesboro, NC
Disclaimer: ThriftyFun.com cannot accept any responsibility for any injury or damage that you may cause to yourself, others, or property when following any advice given on this site. Read the full disclaimer: http://www.thriftyfun.comdisclaimer.ldml If you find any information on ThriftyFun.com or in our newsletters that is either erroneous and/or potentially harmful to others, please Contact Us, immediately.