|
| Source: http://www.thriftyfun.com/tf95179616.tip.html |
Bead and Sequin Ornaments (Grandma Tutu's)By Stella Rivet
Supplies:
Directions: These are three basic steps you will use to make your bead and sequin ornament. Step one: Take a pin and put beads on it. I used two beads of different colors, one green, one iridescent, I wouldn't exceed three beads depending on there size. You want enough pin to stick inside the ball so that it won't fall off easily. Step Two: Put a sequin on the pin after the beads (I used one green sequin). Step Three: Stick the pin, with the beads and sequin on it, into the foam ball.
As you stick sequins into the ball, have them overlap slightly. Continue these steps until you have encircled the ball. Then Start another circle going around the ball the other direction so the circles cross. This creates four sections. Fill in each section with pins so that you can't see any of the white on the ball.
Creating The Hanger Determine where you want the top of the ball to be. Use the ribbon to make a loop for the ornament to be hung by. Then attach the ribbon to the ball with pins that have the beads and sequin on it. I used three or four pins to secure the ribbon in place.
Variation: If you do not want to cover the entire ball you can buy satin ball ornaments instead. Then you can decorate those with less bead a sequins and not worry about letting the white foam show through. About The Author:
|
| Source: http://www.thriftyfun.com/tf95179616.tip.html |
|
© 1997-2009 ThriftyFun.com
Disclaimer: ThriftyFun.com cannot accept any responsibility for any injury or damage that you may cause to yourself, others, or property when following any advice given on this site. Read the full disclaimer: http://www.thriftyfun.comdisclaimer.ldml If you find any information on ThriftyFun.com or in our newsletters that is either erroneous and/or potentially harmful to others, please Contact Us, immediately. |