Emulsion Paint on Cord Carpet

Feedback About This Post:

RE: Emulsion Paint on Cord Carpet

Have you tried goop? Is the carpet a large piece? Can you pick up the carpet and work over a pan outside? I would try paint thinner, and anything else after that if it did not clean. Go to an artists shop and find what they have to remove paint.

You can then use soap as long as you can rinse and rinse and rinse the section of the carpet. If you get soap in your carpet, it will attract dirt and there will always be a spot. I would work what I was using into the fibers with a soft brush. I use a large brush to groom my carpet and cause the strands to stand up after I clean it.

Water will sometimes shrink your carpet when it dries. Some installers use this method of laying the carpet so they don't have to stretch it. I do not recommend this. When I used to clean carpets that had been layed using this method, they were bumpy til they dried.


Jill

Post By Jill (Guest Post)

RE: Emulsion Paint on Cord Carpet

Emulsion is water soluble so a good scrubbing with lots of soapy water should help - and a cord carpet will probably stand up to it well. Scrub and blot until you remove all the paint without soaking the carpet too much. Try asking at the local DIY store - they may have something to help the process.

Regards

Jo

Post by Jo Bodey

Disclaimer: ThriftyFun.com cannot accept any responsibility for any injury or damage that you may cause to yourself, others, or property when following any advice given on this site. Read the full disclaimer: http://www.thriftyfun.comdisclaimer.ldml If you find any information on ThriftyFun.com or in our newsletters that is either erroneous and/or potentially harmful to others, please Contact Us, immediately.