|
| Source: http://www.thriftyfun.com/tf17406252.tip.html |
Cleaning Cast Iron Frying Pans or Waffle IronsAs for the waffle iron that has been washed, or scorched, no fear. Fill it with salt and heat it for 45 minutes to an hour. It can be repeated if necessary. I always have coarse salt left after pickling, afterward I throw the salt on the ice outside if it's winter. Never throw salt on cement though. It eats the cement. By Siris from Dawson Creek, BC, Canada Feedback About This Post:RE: Cleaning Cast Iron Frying Pans or Waffle Irons
This is an algorithm I use for cleaning my cast-iron skillets. As a general rule I NEVER use any soap, detergent or any chemicals. These will not only strip away all of the seasoning, but they will also absorb into the iron and (in my humble opinion) ruin the skillet. I never use water, either, but use oil instead. Water can lead to rusting. Iron is a porous metal and will absorb anything it comes in contact with. The idea is to fill those pores with oil from foods. That is what "seasoning" is. Post By Alex K. (Guest Post) RE: Cleaning Cast Iron Frying Pans or Waffle IronsHow do you get the rust of with out using caustic products? Post by minymont RE: Cleaning Cast Iron Frying Pans or Waffle IronsIf you want to bring your iron pots back to like new, get some Red Devil Lye. Put this in 5 gallon bucket with warm water. Be very careful and use gloves.Place your pots in this solution for a few days. Take them out, using gloves, and look. Rinse with water hose. If all the goop is off take inside and scrub good with Dawn dish liquid. Rinse well. Put on heat to warm up and then grease as usual. When hot, put under cool water. dry good and repeat heat treatment.I have cleaned hundreds of cast iron pots using this method. I go to yard sale to find them and give them away like new again. I hope this helps you to get new pots again. Post by jodee433 RE: Cleaning Cast Iron Frying Pans or Waffle Irons
I may try your tip about using salt in the waffle iron, but I have a VERY antique one and fear that the salt might PIT the metal which seems to be aluminum. Post By Lynda (Guest Post) RE: Cleaning Cast Iron Frying Pans or Waffle IronsI never use soap and water to clean cast iron. Instead, I pour in baking soda and salt then scrub as if I were using SOS or Brillo. It's easier if the pot is still slightly warm, but will work in a cold one as well. After all the burnt bits are gone, I wipe out the pot with a dry cloth until all the salt and soda are gone, then spray with Pam. Remember to spray the lid, too! Post by hsorbits |
| Source: http://www.thriftyfun.com/tf17406252.tip.html |
|
© 1997-2009 ThriftyFun.com
Disclaimer: ThriftyFun.com cannot accept any responsibility for any injury or damage that you may cause to yourself, others, or property when following any advice given on this site. Read the full disclaimer: http://www.thriftyfun.comdisclaimer.ldml If you find any information on ThriftyFun.com or in our newsletters that is either erroneous and/or potentially harmful to others, please Contact Us, immediately. |