Source: http://www.thriftyfun.com/tf372168.tip.html

Umbrella Table Plastic Ring Replacement

The plastic ring on our outdoor glass umbrella table broke a couple of years ago in a wind. To fill the gap between the umbrella and the table, I cut an inverted Yoplait Yogurt container and forced it down into the hole. It has lasted for over two years now. What a surprise.

By springmaid5

Feedback About This Post:

RE: Umbrella Table Plastic Ring Replacement

My table is metal & I thought I had lost the ring so I made one from the top of a spray paint can.
A lot of them have a smaller ring inside to go on top of the spray button . I save them to mark posts & even outlined a small garden with them one time when I seemed to be painting everything in sight.
Anyhoo,I cut up the side to the flat top,cut around it ,then punched a hole in the middle with a nail & used a craft knife to cut out the center close to the edge of the small ring . It worked just fine & I eventually found the official one.
I haven't used my table much in recent years due to too many bugs. However they are less now so who knows maybe a nice fall picnic couldn't hurt.

Post By Linne Dodds (Guest Post)

Source: http://www.thriftyfun.com/tf372168.tip.html
© 1997-2009 ThriftyFun.com

Disclaimer: ThriftyFun.com cannot accept any responsibility for any injury or damage that you may cause to yourself, others, or property when following any advice given on this site. Read the full disclaimer: http://www.thriftyfun.comdisclaimer.ldml If you find any information on ThriftyFun.com or in our newsletters that is either erroneous and/or potentially harmful to others, please Contact Us, immediately.