Egg Carton Bulletin Board

• 3 Egg Cartons
• Scissors or x-acto knife
• Masking tape
• ribbon, yarn or string
• Hole Punch
• Optional: Paint, glitter and other decrotive items.

Directions:

Cut the lids off the egg cartons leaving the bumpy part of the container. On one leave the flap that you use to close the egg carton with but with the other two cut that piece off.

Using masking tape, secure each carton to each other, like shown in the picture. Make sure to leave the egg carton with the flap on the outside.

Punch two holes in the flap approximately 4" apart.

Tie a knot on one end of your ribbon, yarn or string big enough so it will not be pulled through the hole. Pull string though hole leaving the knot on the backside. Pull the end of the string through the second hole and tie a knot.

Find some tacks and picture and pin them to your new recycled bulletin board!

If you want to make your bulletin board fancy you can paint it, glitter it or decorate it any other way you desire.

About The Author:
Stella contributes craft ideas to ThriftyFun.com. If you have any craft ideas that you would like to share with Stella and ThriftyFun community, please submit them here.

Disclaimer: ThriftyFun.com cannot accept any responsibility for any injury or damage that you may cause to yourself, others, or property when following any advice given on this site. Read the full disclaimer: http://www.thriftyfun.comdisclaimer.ldml If you find any information on ThriftyFun.com or in our newsletters that is either erroneous and/or potentially harmful to others, please Contact Us, immediately.