Removing Fused Interfacing
Rose from Malvern, PA
Feedback About This Post:
RE: Removing Fused Interfacing
Just iron again on the interfacing until it heats up and peel if off. I've not had any trouble doing this before but it is difficult to remove any left over goo. Good Luck!
Post By Becky (Guest Post)
RE: Removing Fused Interfacing
I've been through this & it's not fun... & the truth is, sometimes it's impossible to remove it, but if you want to give it a try, what you do is take a piece of light colored 100% cotton fabric & lay it over the interfacing, then just iron the cotton it until the interfacing underneath it warms up enough to get a corner pulled up, then slowly keep warming up the interfacing & pulling it up while it's warm (or hot)... Depending on how well you've fused it & how long it's been sitting will decide if it will or won't come away from the fabric. But remember this Pellon is MADE to be washed, dried & dry-cleaned without coming up...
* You could also e-mail the Pellon company & ask them.
You've probably used an interfacing that was just a wee bit thicker than was needed for that particular fabric. I've done this many times when I've not had the interfacing I needed, but now, I recently stocked up on different kinds when it was 50% off, so hopefully this won't happen to me again. I personally like the knitted interfacing, the one for knits because it moves & bends a little when you do.
Post by Cyinda
Disclaimer: ThriftyFun.com cannot accept any responsibility for any injury or damage that you may cause to yourself, others, or property when following any advice given on this site. Read the full disclaimer: http://www.thriftyfun.comdisclaimer.ldml If you find any information on ThriftyFun.com or in our newsletters that is either erroneous and/or potentially harmful to others, please Contact Us, immediately.