Source: http://www.thriftyfun.com/tf76229346.tip.html

Drilling Slot For Glass Block Bank

I want to make a glass block bank. How do I drill the slot?

By Jaime from Alberta, Canada

Feedback About This Post:

RE: Drilling Slot For Glass Block Bank

Begin with a glass block. Use an electric drill with a diamond drill bit to create a hole in the side of the block large enough to feed through a string of lights. Clean the dust out of the block. If desired, you can paint the inside of the block with a frosted glass spray paint, or you can paint a picture on the front of the block. For a standard glass block, about 8-by-8-by-4 inches, choose a small set of lights with about 20 bulbs on a string. Feed them through the hole. Wrap a ribbon around the block and add a large bow on top. Plug in the package to see it light up. Good luck.

Post by kffrmw88

Source: http://www.thriftyfun.com/tf76229346.tip.html

Disclaimer: ThriftyFun.com cannot accept any responsibility for any injury or damage that you may cause to yourself, others, or property when following any advice given on this site. Read the full disclaimer: http://www.thriftyfun.comdisclaimer.ldml If you find any information on ThriftyFun.com or in our newsletters that is either erroneous and/or potentially harmful to others, please Contact Us, immediately.