Source: http://www.thriftyfun.com/tf80001434.tip.html

Painting After Removing Wallpaper

I have taken down wallpaper and patched the walls, but when I went to paint the wall it bubbled up in spots. What's the problem?

Sharon

Feedback About This Post:

RE: Painting After Removing Wallpaper

I just removed three layers of wallpaper - the top one was the textured wallpaper and it was painted. I used a combination of my old standby ammonia and hot water and then also tried the newer suggestion of fabric softener. The combination seemed to work well - the fabric softener on the old vinyl type wallpaper and the ammonia on the backing.

I then TSPd the wall with a scotch brite scrubbing pad and rinsed it but noticed I still had a slight film of something so I went over everything again with a mixture of white vinegar and hot water. Since this is the first time I have used fabric softener could this be the cause of what appears to be a film of some kind? I plan to start painting tomorrow but don't want my paint to "alligator".

Post By Marilyn K. (Guest Post)

RE: Painting After Removing Wallpaper

Sharon, Normally when you take down wall paper, you scrub the walls down with tsp (trisodium phosphate, purchased @ hardware store) and rinse with clear water and sponge until all the paste is off. Let dry and paint. I am not sure what you meant by patching. Hope this helps.

Post By Enter your name. (Guest Post)

RE: Painting After Removing Wallpaper

If the patches were not completely dry, you will get bubbles.

Post by Lynn

RE: Painting After Removing Wallpaper

Was the glue residue off the walls with TSP

Post by PICO

RE: Painting After Removing Wallpaper

I don't know what the problem could be, but you might try texturizing the walls before you paint. You can find some relatively inexpensive spray-on texture that dries pretty quickly, and it may then give the paint something to stick to. We got our texture product at Wal-Mart.

Post By Kristen (Guest Post)

RE: Painting After Removing Wallpaper

Give the wall area a good 'sanding' with 000 grit or steelwool. Then wipe off the residue. You could also have a moisture build up there for bubbling. Moisture and paint do not mix. We have an exterior issue with paint not staying on the house due to moisture in the new wood from the get go.

Post by T&T Grandma

Source: http://www.thriftyfun.com/tf80001434.tip.html
© 1997-2009 ThriftyFun.com

Disclaimer: ThriftyFun.com cannot accept any responsibility for any injury or damage that you may cause to yourself, others, or property when following any advice given on this site. Read the full disclaimer: http://www.thriftyfun.comdisclaimer.ldml If you find any information on ThriftyFun.com or in our newsletters that is either erroneous and/or potentially harmful to others, please Contact Us, immediately.