Source: http://www.thriftyfun.com/tf811986.tip.html

Cleaning Smoke of a Porcelain Figurine

I have a porcelain figurine with a lot of smoke damage. My husband once smoked and the figure is all yellow from the smoke. How can I safely clean it?

Mollylena

Feedback About This Post:

RE: Cleaning Smoke of a Porcelain Figurine

I swear by pine sol and water, it'll peel the smoke and yellow off anything; walls, figurines, windows, even fabrics. 1/4 cup into the washer with the smoke smelly stuff, no detergent, no bleach either. Wash through one cycle, then wash again to remove the pine sol residue, you could use detergent the second time but still no bleach. Whatever the articles were will come out fresh as new. This works for tobacco smoke and smoke damage from a fire. Also works good for mildewed items, just be gentle if the fabric calls for it.

Post By Enter your name. (Guest Post)

Cleaning wedgewood figurines?

I have acquired some wedgewood figurines that look rather dirty, how shall I clean them?

Post By lenodog@aol.com. (Guest Post)

RE: Cleaning Smoke of a Porcelain Figurine

Hi,

Before cleaning with any commercial cleaner, you must be sure the painted design is under the glaze. You can tell this by holding the piece to the light to see if the paint has a shine over it. If not, then the design was done after the firing and may come off with rubbing with any kind of brush or cleaner. Most conservationists use an enzyme cleaner... but if you don't have access to one, then good old 'spit' works... yes, spit.. it may seem a bit gross, but it is so neutral as to not harm the paint... use a soft Q-tip and gently rub over each area a bit at a time. if you are patient (and it takes patience and lots of time) it will work well. Often you cannot tell if there is any paint over the glaze until it is clean, but why take the chance. It works well.... then if there is no paint that is applied over the glaze when you are finished, you can wash in a mild liquid detergent. Make sure there are no holes in the piece as there are often in figurines. Some of the 19th century upright figures have holes for sand so the figure can be weighted. if water gets in the holes, mould can grow so easily... it likes dark and damp places. So be sure not to immerse in water. All the best with your piece.

Cauleen

Post By Cauleen (Guest Post)

RE: Cleaning Smoke of a Porcelain Figurine

If nothing else works, try toothpaste made specifically for smokers and very gently brush it on and rinse. It may remove the yellow smoke stain.

Post by gannon

RE: Cleaning Smoke of a Porcelain Figurine

put into your sink bowl,then spray with 409 spray.it does a wonderful job. then rinse off with just warm water. i do this with my little hurrican lamps.

Post By Enter your name. (Guest Post)

RE: Cleaning Smoke of a Porcelain Figurine

Is there any reason why you can't just wash it? If it is fully glazed I would just wash it in warm soapy water with a soft cloth. Wash it in a plastic bowl or place a towel in the sink to ensure it doesn't get knocked/chipped on the sink or tap/faucet. Use a soft toothbrush to get in any cracks and crevices.

Regards

Jo

Post by Jo Bodey

RE: Cleaning Smoke of a Porcelain Figurine

i don't know if this will work ? but i use denture tablets to clean out old dirty bottles & it work just fine! it doesn't hurt dentures so it shouldn't your vase !

Post By brenda. (Guest Post)

Source: http://www.thriftyfun.com/tf811986.tip.html
© 1997-2009 ThriftyFun.com

Disclaimer: ThriftyFun.com cannot accept any responsibility for any injury or damage that you may cause to yourself, others, or property when following any advice given on this site. Read the full disclaimer: http://www.thriftyfun.comdisclaimer.ldml If you find any information on ThriftyFun.com or in our newsletters that is either erroneous and/or potentially harmful to others, please Contact Us, immediately.