Source: http://www.thriftyfun.com/tf82773801.tip.html

Help With Panel Knitting

When doing panel knitting, I don't understand when it states to turn at last peg then wrap last peg one more time. When I try to go back for the second roll then tie off the last peg does not tie off right.

By Jonielle from CA

Feedback About This Post:

RE: Help With Panel Knitting

Jonielle,
You can start by making a loop not slide the loop (lp) on the first peg. No need to tie off afterwards and start going around the pegs and then go around all the pegs again for second lp and start from there. That all there is to it. After that you can use a long crochet needle to take the last of the lps off of whatever single knitting project you're doing and cast off as usual. You can take a craft sewing needle that probably came with you board and sew those ends in the finish project to hide that leave it out as a start of a finge.
I hope I helped.
Pam G.
Alabama.

Post by Pam G.

RE: Help With Panel Knitting

Here are panel knitting instructions and some illustrations that include turning at the last peg and wrapping the last peg twice. Hope this helps.
http://www.provocraft.com/projects/kniftyknitter/panel.knit.html

Post by Anonymous

Source: http://www.thriftyfun.com/tf82773801.tip.html

Disclaimer: ThriftyFun.com cannot accept any responsibility for any injury or damage that you may cause to yourself, others, or property when following any advice given on this site. Read the full disclaimer: http://www.thriftyfun.comdisclaimer.ldml If you find any information on ThriftyFun.com or in our newsletters that is either erroneous and/or potentially harmful to others, please Contact Us, immediately.