Painting Glass Vases

Feedback About This Post:

Painting Glass Vases with peace sign

Help,I have to paint a 100 glasses with the peace sign on wine glovets, I tried putting the design inside the glass, drawing it over the glass,and tried to make sticky stencils, I´m getting frustrated the client wants them perfect even, on colors that does not come out in the dishwasher or microwave, the bad part is I can´t get them even, because with the stencil I made. It can´t get perfectly attached to the glass ,too round and the paper is too plain, then the painting gets inside the lines,and it´s a mess. Please help!

Post By Verokimbo (Guest Post)

RE: Painting Glass Christmas Ornaments

I am wanting to paint glass ornaments and need to know where to start? What kind of paint is best to use? Do I need to put some type of finish to seal the paint? I will take any suggestions or guidance. Is there a web site I can visit?

Post By Brenda S (Guest Post)

RE: Painting Glass Vases

If you have pictures from magazines or from the internet that are not very complicated, you can tape them to the inside of the vase instead of using stencils or templates. You can even draw the outline of flowers and vines on paper and tape that to the inside of the vase, use a fine paint brush to paint the outline then fill in and shade as desired.

Post By Melanie from Wilkesboro, NC (Guest Post)

RE: Painting Glass Vases

Thank you for the feedback. I have a problem with the paint running and peeling off when I remove the sticky stencil. Any ideas on this one?

Post by walters291

RE: Painting Glass Vases

First, use glass paint from craft store. Michael's always has 40% coupons & I evenutally got the colors I needed. This works on glass that needs to be washed. It cleans up like acrylics, doen't ruin your brushes.

It's been a few years since I made stencils, but I think I got the "transparent" soft plastic sticky backed sheeting from Michael's. It's made by Kittrich and I think it's called "Magic Cover". If you have a photo of what you want to paint, you put this plastic over it & draw your design to be cut out with a craft knife. I made 3 sizes of lady bugs that were from small stickers & I went to Office Depot & had them enlarged from 1/2 inch to 4 inches. Put the plastic over, drew, cut & then stuck this sticky backed stencil to glass pots, did same with hearts on wine glasses. Best stuff for a curved surface.

Hope this wasn't too confusing. Good luck. EK

Post By Elizabeth (Guest Post)

Disclaimer: ThriftyFun.com cannot accept any responsibility for any injury or damage that you may cause to yourself, others, or property when following any advice given on this site. Read the full disclaimer: http://www.thriftyfun.comdisclaimer.ldml If you find any information on ThriftyFun.com or in our newsletters that is either erroneous and/or potentially harmful to others, please Contact Us, immediately.