Source: http://www.thriftyfun.com/tf93217780.tip.html

Repairing a Glider Chair

I picked up a lovely glider chair from the street, but the seat support is broken. There are 3 curved springs with a square of white cloth (looks like linen) on top. They are stapled into the wood, but some of the staples fell off and so did the springs. Any idea about how to fix it will help. Thanks.

yyhuang from LA, California

Feedback About This Post:

RE: Repairing a Glider Chair

Hi yyhuang from LA, California,

I make and/or repair various types of furniture. It looks like you may be able to just re-attach the springs with new clips (if your going to take it apart and redo the seat). Or you could use some zig-zag repair kit parts to reattach the springs from underneath.

HOWEVER, it looks like the only fabric you have left is the liner for the bottom of the seat. If so, you will want to get a peice of foam and some material to cover the same. (that shouldn't be too expensive either).

Once you set-up the springs correctly and position the foam just neatly staple the material underneath one side of the seat and carefully pull the material across and under the other side stapling there as well. Take care to NOT pull the material too hard or too little (this can give you crease lines or saging bumps). Repeat the process with the two other opposite sides (neatly trimming out the material however you want it to lay near the corners).

l can sell you some of my extra supplies at cost (i think the basic manufacturing clips were like 4/$1 (the heavy duty spring brackets are like 2/$3). Anyway this can be an easy fix, it just depends on what YOU want to do with it:-)

Post by purpledama

RE: Repairing a Glider Chair

I have a chair just like that. My problem was that whatever cushion I put on it I could feel the springs through. Within a few short days
I solved the problem by going to the lumber yard and getting a board that fit the seat and placed it on. No problems now and I have had the chair for over 5 years. Lumber stores usually have a scrap bin or they sometimes cut the wood for you. They cut mine for $0.50 a cut.

Post By soyzicks (Guest Post)

RE: Repairing a Glider Chair

I would go to an upholstery shop and see if you can buy some springs to replace the missing springs. If not, maybe they have something else to repair it. I have some old furniture that has what looks like strong elastic that is about 3 inch wide. You stretch it from one side of the frame to the other and staple it in place. Loretta

Post By Loretta B. (Guest Post)

RE: Repairing a Glider Chair

I have a chair similar to this. In our town there is antique furniture shop. I asked what it would cost to repair, he said not much, under $30. He does repair in back of the shop. I think most shops do like that. It might be worth checking into.

Post by Ariela

Source: http://www.thriftyfun.com/tf93217780.tip.html

Disclaimer: ThriftyFun.com cannot accept any responsibility for any injury or damage that you may cause to yourself, others, or property when following any advice given on this site. Read the full disclaimer: http://www.thriftyfun.comdisclaimer.ldml If you find any information on ThriftyFun.com or in our newsletters that is either erroneous and/or potentially harmful to others, please Contact Us, immediately.