social

Losing Power When I Put a Light Bulb in a Socket?

I have an electrical problem. I have power at my light switch and fixtures, but when I put a light bulb in the socket the power is no longer there. If I take the bulb out and power is back.

Advertisement



Kimeo from St. Paul, MN

Add your voice! Click below to answer. ThriftyFun is powered by your wisdom!

 

Diamond Feedback Medal for All Time! 1,023 Feedbacks
June 24, 20060 found this helpful

Dear Kimeo
A voltage reading on a digital instrument does not necessarily mean that there is real power there. If you still read the same voltage when a load is connected, THEN you have proper connections.

Most likely you have either wires mixed up or a broken wire somewhere or a badly corroded connection. A totally corroded connection lets enough electricity flow through it to show on a digital meter, but not enough to light up a lightbulb.

Advertisement

Use an electrician's test light or a trouble light or a table lamp connected with insulated alligator jumpers to your meter leads. Start at the malfunctioning light and test every access point all the ay back to the breaker until you find a spot where the test light comes on and the voltage reads 110 or more Volts while the light is lit. The problem will be at that spot or immediately downstream from it.

Good Luck
DearWebby
webby.com/.../

 
Anonymous
July 17, 20210 found this helpful

I had the same problem with a set of 6 outdoor fixtures set atop masonry columns at the end of a driveway. We checked voltage at all splices and ensured that there were no broken wires or short circuits. Everything checks out, 120v at each point until we reconnect the fixtures and screw in a bulb in any of the sockets. I tested each point with a small load of my 18v battery charger to see if the problem was repeated but the charger worked fine.

Advertisement

The draw from the charger is similar to what one of the LED candelabra bulbs would draw. Tried brand new bulbs as well. Very strange. I lose voltage from hot to neutral but hot to ground is still 120v.

 
July 17, 20210 found this helpful

I had the same problem with a set of 6 outdoor fixtures set atop masonry columns at the end of a driveway. We checked voltage at all splices and ensured that there were no broken wires or short circuits. Everything checks out, 120v at each point until we reconnect the fixtures and screw in a bulb in any of the sockets. I tested each point with a small load of my 18v battery charger to see if the problem was repeated but the charger worked fine.

Advertisement

The draw from the charger is similar to what one of the LED candelabra bulbs would draw. Tried brand new bulbs as well. Very strange. I lose voltage from hot to neutral but hot to ground is still 120v.

 
Anonymous
December 10, 20210 found this helpful

Bad switch

 

Add your voice! Click below to answer. ThriftyFun is powered by your wisdom!

 
Categories
Home and Garden Repair Home ElectricalJune 24, 2006
Pages
More
🌻
Gardening
👒
Mother's Day Ideas!
🐛
Pest Control
Facebook
Pinterest
YouTube
Instagram
Categories
Better LivingBudget & FinanceBusiness and LegalComputersConsumer AdviceCoronavirusCraftsEducationEntertainmentFood and RecipesHealth & BeautyHolidays and PartiesHome and GardenMake Your OwnOrganizingParentingPetsPhotosTravel and RecreationWeddings
Published by ThriftyFun.
Desktop Page | View Mobile
Disclaimer | Privacy Policy | Contact Us
Generated 2024-04-08 04:19:41 in 2 secs. ⛅️️
© 1997-2024 by Cumuli, Inc. All Rights Reserved.
https://www.thriftyfun.com/tf11808539.tip.html