social

Removing Broken Light Bulbs?

I would like to know how to remove broken light bulb.

By Elisa from San Jose, CA

Add your voice! Click below to answer. ThriftyFun is powered by your wisdom!

 
August 11, 20190 found this helpful
Best Answer

SHUT OFF SWITCH FIRST TO CUT OFF POWER ! If you have a wood broom or mop, unscrew the broom/mop part from the handle, and use the threaded end of the broom handle to unscrew the bulb end from the socket- comes right out- easy peasy ! Use ONLY a wood broom handle in which the threads for the "head" are wood also with NO metal parts. Wood is a poor conductor, so it is safe ( any metal parts can behave as a conductor, so they must be removed prior to using the handle).

 
September 20, 20090 found this helpful

I haven't done this in a while, but here is a way to do it. First disconnect the power to your light, i.e. fuse, breaker etc. That is very important! Do not attempt to do anything before doing this. Take a peeled potato and jam it up into the socket. The potato grabs the piece of light bulb left in there and you should be able to turn it all the way out. Clean the socket well before turning the electricity on again and insert a new light bulb.

 
September 21, 20090 found this helpful

Just had to say "thank you" for the tip of using a new light bulb to remove the old broken one. It worked perfectly!

 

Bronze Post Medal for All Time! 124 Posts
September 22, 20090 found this helpful

I was going to recommend the potato method too. Tried and tested here too. Glad someone beat me to it :)
Monique

 
September 23, 20090 found this helpful

I agree with the cut potato. Just cut the potato in half and press the cut side up into what is left of the bulb (the metal part). Slowly turn to unscrew it.

 
October 23, 20100 found this helpful

I just removed the broken off light bulb in a light socket in my kitchen. I tried the potato hint first and that didn't work. Then I tried the pliers method and that didn't work too well since I had to turn off the power to be safe and it was too dark to see what I was doing. Then I found a neat hint about using tape on the end of a broom handle and this worked great. Just wrap some duct tape, sticky side out, around the end of the broom handle, stick it up into the socket and turn counterclockwise. The broken part came right out. Hope this helps you, too.

 
November 12, 20110 found this helpful

Just tried bjshu2's suggestion about the duct tape on the broom handle and it worked immediately! Had tried everything else and about ready to give up when came across this post. Thank you so much.
Fastsaint

 

Add your voice! Click below to answer. ThriftyFun is powered by your wisdom!

 

September 19, 2009

Use a cut potato to grab and pull a broken light bulb out of its socket to avoid cutting oneself.

By blterri

Editor's Note: The first thing you should do is make sure the light is turned off or lamp is unplugged. One thing you can do that's even better than a potato is crumple up newspaper into a tight ball and use that to turn and unscrew the broken light bulb. The ball of newspaper won't contain as much water as a potato does.

Advertisement


Answers:

Removing Broken Light Bulbs

Something else that works well is a thick sponge. I found this out when I had no potatoes (didn't even consider newspaper.). Anyone have any other ideas for things to use for this?

Terry (03/15/2005)

By terry

Remove a Broken Light Bulb

If a light bulb breaks off in the socket while trying to remove it, use a small raw potato to remove the broken bulb. Lightly push the potato on the broken end of the bulb and turn to unscrew.

This is much easier and safer than using metal pliers to remove it and risk getting cut or electrocuted. Always turn off the circuit breaker when changing a ceiling bulb and pull the power plug on a lamp. An apple might work as well, though I have only used potatoes. This is a great trick.

By hedrivesz (03/23/2005)

By ThriftyFun

Removing Broken Light Bulbs

Another thing you can try is using a new light bulb to unscrew the old broken socket, it works great when the broken socket is screwed on tight (02/17/2006)

Advertisement


By Vanessa A.

Removing Broken Light Bulbs

Another object you can use to take out a broken light bulb is a bar of soap. Just insert the edge of soap and twist, but make sure the bar of soap is dry. (06/01/2008)

 
Categories
Home and Garden Home Improvement Lighting and ElectricSeptember 19, 2009
Pages
More
🍀
St. Patrick's Ideas!
🎂
Birthday Ideas!
💘
Valentine's Ideas!
Facebook
Pinterest
YouTube
Instagram
Categories
Better LivingBudget & FinanceBusiness and LegalComputersConsumer AdviceCoronavirusCraftsEducationEntertainmentFood and RecipesHealth & BeautyHolidays and PartiesHome and GardenMake Your OwnOrganizingParentingPetsPhotosTravel and RecreationWeddings
Published by ThriftyFun.
Desktop Page | View Mobile
Disclaimer | Privacy Policy | Contact Us
Generated 2024-02-14 07:28:00 in 1 secs. ⛅️️
© 1997-2024 by Cumuli, Inc. All Rights Reserved.
https://www.thriftyfun.com/tf277221.tip.html