social

My Pool Turned Green?

I woke up one morning to find my pool completely green. I tried 16oz of super shock (only calls for 3 3/4 oz) its still green. Can anyone help me?

Advertisement



Nene from Keeseville, NY

Add your voice! Click below to answer. ThriftyFun is powered by your wisdom!

 
July 14, 20080 found this helpful

I was just visiting friends in NY and they had the same problem. They were told to put salt in their pool. The ph and sulpher was ok but that the salt would clear it up. You could try it out. What have you got to lose.

 
July 14, 20080 found this helpful

I was told by a man with his own pool business to
pour plain baking soda in and let it mix. Just keep
adding it until it clears up. You can use as much

Advertisement


as you need without it being harmful to the pool or
you.

 
By Reta E (Guest Post)
July 14, 20080 found this helpful

First-shock the pool. Second-scrub down the walls. Third-get the phosphates out by using a phos-free chemical that pool stores carry. Fourth-put that in and run the pump 24 hours. That should clear it up.

 
By (Guest Post)
July 18, 20080 found this helpful

Check your ph balance. Keep vac'ing it and it will go away eventually.

 
By IVY (Guest Post)
September 13, 20080 found this helpful

I am right now looking at my green swamp that used to be a sparkling clear pool! I let it go a few days and it turned a brighter shade of green then grass. I put 2 gallons of shock, back washed it, and have a chlorine tablet floating. Usually it clears up pretty fast but its been 4 hours and we still cant see the bottom, or anything else.

Advertisement

I am hoping it clears by tomorrow or I will be taking some advice of other people on here; baking soda, salt, bleach and water? Ugh! I just wanna vacuum it and close it for the season. Now its hotter than it was in august and I'm running the filter 24 hours. Will update when things are looking 'brighter'!

 
September 1, 20090 found this helpful

I had the same problem. Get some floc from your pool company. Follow the directions on the bottle. Basically, you switch your filter by recirculating the water back into the pool, bypassing the filter. Before you add the floc, brush the sides of the pool good. Add correct amount of floc, circulate (with water bypassing the filter) for 2 hours. Then, turn off the pump and let the pool sit undisturbed for 12-48 hours. The polymer will thicken the algae and the algae will drop to the bottom.

Advertisement

Being very careful not to disturb the algae on the bottom, vacuum the pool to waste. Add fresh water since your pool level will drop. Backwash the filter. Set the sand filter to filter and start the pump. Remember, the floc does not kill the algae. You must vacuum the dirty green water to waste. Check the chlorine level. Add shock if level drops below 3 ppm. This worked for me.

 

Add your voice! Click below to answer. ThriftyFun is powered by your wisdom!

 
Categories
Home and Garden Home Improvement Pools and Hot TubsJuly 14, 2008
Pages
More
🍀
St. Patrick's Ideas!
💘
Valentine's Ideas!
🎂
Birthday Ideas!
Facebook
Pinterest
YouTube
Instagram
Categories
Better LivingBudget & FinanceBusiness and LegalComputersConsumer AdviceCoronavirusCraftsEducationEntertainmentFood and RecipesHealth & BeautyHolidays and PartiesHome and GardenMake Your OwnOrganizingParentingPetsPhotosTravel and RecreationWeddings
Published by ThriftyFun.
Desktop Page | View Mobile
Disclaimer | Privacy Policy | Contact Us
Generated 2024-01-26 12:48:22 in 2 secs. ⛅️️
© 1997-2024 by Cumuli, Inc. All Rights Reserved.
https://www.thriftyfun.com/tf31170587.tip.html