social

How Do I Clean the Condenser Coils on a Maytag Refrigerator?

I have a Maytag French door refrigerator that is freezing my produce. The owner's manual tells me to clean the condenser coils, but it doesn't tell me where they are or how to do it. There were no similar questions in the 3000+ previously asked questions.

Advertisement

The back of the frig is enclosed so there's no access there, but there is a small faceplate under the floor of the frig, is that where they are? How do I get the faceplate off? It doesn't just pull off, but there are no screws that I can find holding it in place. And do I vacuum these coils or maybe use an air compressor with blower unit attached? Any help here will be greatly appreciated, thanks.

By Sandy from Bandon, OR

Add your voice! Click below to answer. ThriftyFun is powered by your wisdom!

 
May 16, 20100 found this helpful

I would contact Maytag through the phone or with an e-mail and ask them. Or go to your local Maytag dealer and ask them.

Advertisement

Some models do not need cleaning. If you do not have access to the coils, yours may be one of them.

 
April 18, 20170 found this helpful

This reticular (side by side) should under go cleaning.
Under the refrigerator doors is a face plate held by clips. Remove the face plate (on the left of this is cartridge for water that has its own cover ). Get a flash light and look in to the exposed cavity. Your should see atlas 3 rows of coils. If you have never cleaned they would be dirty. There are brushes available for cleaning although i find difficult as brushes are larger than the distance between loops of the coil. To clean just use vacuum cleaner with a wand. Alternate ( if you have ) would be use of compressed air.

 

Bronze Post Medal for All Time! 104 Posts
May 18, 20100 found this helpful

There is a brush made specifically for this; I have one I use. There should be a plate at the bottom of the fridge that just snaps off. After you get it off run the brush back and forth between the coils and the brush collects all the "stuff".

Advertisement

Check a hardware store and I think you'll find one. It's a long skinny brush.

 
Anonymous
October 18, 20170 found this helpful

The coils on my Maytag run from left to right. You can't get a brush in there

 
May 22, 20100 found this helpful

Thank you all very much for the info!! Found the brush at the local hardware store, finally got the faceplate off thanks to the people at said hardware store, and cleaned those dratted coils. Woo hoo! Now we'll see if that fixes the problem. if not, I'll be back for more info. S

 

Add your voice! Click below to answer. ThriftyFun is powered by your wisdom!

 
Categories
Home and Garden Repair Appliances RefrigeratorMay 16, 2010
Pages
More
👒
Mother's Day Ideas!
🐰
Easter Ideas!
🌻
Gardening
Facebook
Pinterest
YouTube
Instagram
Categories
Better LivingBudget & FinanceBusiness and LegalComputersConsumer AdviceCoronavirusCraftsEducationEntertainmentFood and RecipesHealth & BeautyHolidays and PartiesHome and GardenMake Your OwnOrganizingParentingPetsPhotosTravel and RecreationWeddings
Published by ThriftyFun.
Desktop Page | View Mobile
Disclaimer | Privacy Policy | Contact Us
Generated 2024-03-29 06:31:54 in 3 secs. ⛅️️
© 1997-2024 by Cumuli, Inc. All Rights Reserved.
https://www.thriftyfun.com/tf44744712.tip.html