social

Keeping Light Bulbs From Vibrating Loose?

Our outdoor light fixture bulbs become loose with vibrations from opening and closing the door. Is it safe to put something around the bulb's threads so the bulbs will not become loose?

Advertisement

By carla from Greensboro, NC

Add your voice! Click below to answer. ThriftyFun is powered by your wisdom!

 
September 2, 20090 found this helpful

Do NOT wrap anything around the threads of the bulb. It could act as an insulator and the bulb will not light but a worse problem is you could start a fire.

 
September 2, 20091 found this helpful

I don't know why you couldn't put a small, thin strip of aluminum foil around the base(don't let the foil extend above the socket-base). The base is aluminum. Another method would be to securely anchor the bulb and socket-base with a piece of electrical tape[although the tape may melt due to the heat of the bulb].

Advertisement

Maybe you could try closing the door with less force, or is this door used primarily in 'domestic disputes'?

 
September 3, 20090 found this helpful

Foxrun is right. Do not put anything around the bulb! Not even aluminum foil. A dead short could start a fire. How old is the fixture? That may be part of the problem. If it is worn through the years the bulb could be loose.

 

Gold Post Medal for All Time! 969 Posts
September 4, 20090 found this helpful

By all means, don't alter the light. If you flip the breaker, you can go into the fixture and perhaps tighten the screws that hold all the "pieces parts" together, and see if that helps. Then, go to the local Walmart or any store that sells florescents, if you have not already done this, and replace them. They are made better, cost less, and last longer.

Advertisement


Also, never put a wattage of larger than 60 in an enclosed light fixture, even if it is not inside the house. A 60 w. bulb produces the same amount of heat as a human, and glass enclosures can over heat and burst or burn you.

And yes, the door slamming can help if that is reduced, too.

 
September 4, 20090 found this helpful

Check at your local hardware or home store for a light bulb made to withstand this kind of vibration. I can't recall the exact name but I used to get them for the outdoor light at my apartment. They are made from a bit heavier glass (or coated) to help them withstand bumps and they don't seem to vibrate loose in the socket.

Advertisement

They were a little bit more expensive but I didn't have to change them nearly as often, nor did I constantly need to tighten them in the socket.

 
September 5, 20090 found this helpful

I thank everyone for their feedback. I did not mention that these bulbs are solar ones that must be positioned a certain way and a certain looseness for them to work. They easily become too loose so they do not work.

 

Add your voice! Click below to answer. ThriftyFun is powered by your wisdom!

 
Categories
Consumer Advice General AdviceSeptember 1, 2009
Pages
More
🍀
St. Patrick's Ideas!
💘
Valentine's Ideas!
🎂
Birthday Ideas!
Facebook
Pinterest
YouTube
Instagram
Categories
Better LivingBudget & FinanceBusiness and LegalComputersConsumer AdviceCoronavirusCraftsEducationEntertainmentFood and RecipesHealth & BeautyHolidays and PartiesHome and GardenMake Your OwnOrganizingParentingPetsPhotosTravel and RecreationWeddings
Published by ThriftyFun.
Desktop Page | View Mobile
Disclaimer | Privacy Policy | Contact Us
Generated 2024-02-05 17:02:48 in 2 secs. ⛅️️
© 1997-2024 by Cumuli, Inc. All Rights Reserved.
https://www.thriftyfun.com/tf86746852.tip.html