social

Applying Acrylic Nails

December 16, 2013

Who's to Blame for Your Bad Nails?I hear it over and over, clients and others blaming acrylic or gel polish or some other service for damage to their nails. I'm sorry, ladies, but it's not the product doing the damage. It's people who do damage to the nails, not the product. Yes, you're putting a product that sticks to your natural nail and sometimes when that product pops off or rips off, that does do damage. Of course it does. But if it is properly put on and properly removed, and cared for in between appointments, then your natural nail should be in good shape.

Advertisement

So, who does the damage? One of two people or both who are caring for your nails; the client, and/or the nail tech. If you have a nail tech that goes at your nails roughly, improperly uses the e-file (electronic file, not "drill") then you will definitely, guaranteed to have damage done to your natural nail. Which, if you are having acrylic nails put on, you won't see till your nails are removed. Then you're blaming the acrylic when all the while it was your nail tech doing damage every time you came in for a fill.

Do your nails ever hurt when you get your acrylics done? Nail services should NEVER, EVER, hurt. Ever. Sure, sometimes you get nicked by a file and that's painful. But I've had clients tell me about seeing a nail tech and their fingers hurt for days afterwards. Seriously?! Then don't ever go back!

How does a client do damage to their nails? If you get a service done and then treat your nails like they're tools in between appointments then you're doing damage to your own nails. Lifting is caused by so many reasons that it's impossible to name them all. Don't use your nails as a tool, like to remove stickers from products, to pry things open, etc.

Advertisement

Be kind to your nail extensions and you'll be much happier with your nails and you won't have all that damage that you're doing underneath your acrylics that you don't see until you have them removed. You just don't even think about all that twisting and flexing that goes on when you're being rough with your nails.

By the way, your nails do not breathe. You don't need to have your acrylics removed every month. That in and of itself causes most of the damage that is getting done to your nails. Discount salons like to always charge for full sets rather than just have you come in for fills. So, they tell you your nails need to be replaced because your nails need to breathe or whatever. Actually, it's less damaging to just leave your set on. Think about it, you get fills every 2 weeks so you're always growing your nails and always getting new product put on so in about a month or two you have fresh acrylic on your nails! Why get another full set? It's totally not necessary and not even recommended by reputable nail tech's.

Advertisement

You get what you pay for in this industry. If you want a reputable nail tech that is well trained and wants to do a good job and keep your natural nails healthy, then don't go to a discount salon that only cares about making money and cranking people out on a regular basis.

I am a Board Certified Nail Technician and I care about giving my best to all my clients. There's too much misinformation out there. Educate yourself which not only helps you know what to expect from your nail tech but it keeps your nails safe and healthy.

Read More Comments

4 Questions

Here are the questions asked by community members. Read on to see the answers provided by the ThriftyFun community.

July 24, 2006

I have just trained as a nail technician and I am finding things very hard. When I have applied the acrylic it looks great but after buffing I am getting lines in the acrylic and the tip seems a bit lumpy and bumpy.

Please help, I am losing heart.

Answers

July 25, 20060 found this helpful
Best Answer

Hey Dawn, the first thing I would do it get a wider brush than the one you were taught with that seems to make it easier. Then take your time and make sure you've got your acrylic nice and smooth on each nail before moving on to the next. Take a little extra dip back into your liquid with your brush, wipe off the excess and go over the nail one more time to get that extra smoothness.

Advertisement

Better to spend more time on the acrylic application than on trying to remove imperfections afterwards!! If you are finding bumps and stuff when you go to buff then you aren't getting it on smooth enough to start with. Of course then go forward with your roughest buffing and on down to smooth until it looks like glass. Don't give up it just takes practice!!!
Pam

 
By Katherine (Guest Post)
September 16, 20070 found this helpful
Best Answer

Hello Dawn, I am a nail tech of 8yrs now and your right it is hard. Over the years I have given up and started again numerous times, but after practising on my self over and over to work out the lifting problem I finally got it. Make sure you prep the nail bed as best as you can, etch out any shine on the natural nail. you then apply your tips and blend in. Then apply your primer sparingly. When you are ready to apply your acrylic make sure the ball is not too dry as this will cause lifting, however so will a very wet ball. So the secret is to dip your brush into your powder and count to 3 until all dryness disappears, if it takes too long then your ball is to dry. Apply your last ball at the cuticle in a small size so you can pat it down, then using the point of your brush, go around the cuticle edge to make sure no acrylic is touching the skin. Don't make your acrylic balls too big to start off with so really you should have the perfect nail before you even buff, otherwise you will be filing for ever. GOOD LUCK I hope this helps! Katherine

 
By Nailtech2. (Guest Post)
September 18, 20070 found this helpful
Best Answer

The lines you are getting is most likely due to not using the proper grit files. When using tips (I hate using them, I sculpt for the most part), use a 180 grit to reduce the sidewall, and a 240 grit to reduce the length and to blend-in the tip.When applying the acrylic, avoid "patting" the product. Instead, "press" the product with your brush, and move from side to side. Always leave a tiny free margin along the sidewalls and cuticle area of the nail, as touching product to the skin could result in lifting and possible overexposure. Never use the brush to clean up excess product from the sidewall, cuticle area or under the free edge. When applied correctly, there should be no need for any 'clean up' in the first place.

Advertisement


When you are done, refine the shape using a 180 grit file to remove imperfections. After that, move to a higher grit sponge file (buffer) of 220/280 grit. First, use the 220 grit and go over the entire nail. Then use the 280 grit side and repeat. If done properly, by now all lines should be gone from the nail surface. If you are going to be applying polish, then you can stop at this point. If you are going for a high-gloss shine, then continue to buff, but this time move up in grit once again to a buffer/shiner of high grits one each side. There are many different available, but they are run anywhere from 600 or so grit on one side, to 1200-3000 grit on the other side. Some have 3 grits (2 on one side, with the highest grit on the other side for finishing the nail to a high gloss). First use the lowest grit portion, and go over the entire nail. Then, move to the next higher grit (or highest, depending of the file), and repeat. When you are done, you should have some very high gloss nails which are line-free, free of any lumps and bumps, and are consistent in thickness. The proper filing technique should have been taught to you in school. If not, then seek the help of an experienced tech. There is a certain way in which you need to file, and finish nails. It is not a matter of just going over the nail surface in any old direction. Its more of a skill which needs to be perfected over time. Same goes for the acrylic application. It is a skill that takes time to master. Keep practicing, and try to learn from others. It offten helps to sit with an experienced tech who is fully trained, and skilled in her ways. Good luck.

 
Answer this Question

April 27, 2012

I tried the quick dip acrylic and found I can see some of the powder still in the nail after I'm completely finished. I've also had this trouble on regular acrylics, occasionally, just not as bad. I'm not sure what to do. I own a salon and am trying to get better at the acrylic. I've done gel for a while, but for some reason I'm having trouble with this. Help?

By Amanda

Answers


Silver Feedback Medal for All Time! 450 Feedbacks
April 29, 20120 found this helpful
Best Answer

I think you should go to school and get certified for this. If you already have then you should go back to the school for more instruction.

 
Answer this Question

July 3, 2019

Acrylic nails are often done in a salon. However, there are kits you can get to do your own acrylic nails at home.

Placing nail decals on acrylic nails.

In These Pages
Categories
Health & Beauty Beauty Nail TipsAugust 10, 2011
Pages
More
🍀
St. Patrick's Ideas!
🎂
Birthday Ideas!
💘
Valentine's Ideas!
Facebook
Pinterest
YouTube
Instagram
Categories
Better LivingBudget & FinanceBusiness and LegalComputersConsumer AdviceCoronavirusCraftsEducationEntertainmentFood and RecipesHealth & BeautyHolidays and PartiesHome and GardenMake Your OwnOrganizingParentingPetsPhotosTravel and RecreationWeddings
Published by ThriftyFun.
Desktop Page | View Mobile
Disclaimer | Privacy Policy | Contact Us
Generated 2024-01-22 12:56:50 in 11 secs. ⛅️️
© 1997-2024 by Cumuli, Inc. All Rights Reserved.
https://www.thriftyfun.com/tf916887.tip.html