Plugged Nozzle on Swiffer Mop
How do I clean a plugged nozzle on a Clorox Ready/Swiffer mop?
By delmooselech from Chicago, IL
August 20, 20090 found this helpful
I suggest soaking it in hot water. It pops out easily enough and let it sit in the warm/hot water for a bit, take it out, wipe it down, you maybe have to put a toothpick in there to get out the loosened up crud but it's easy.
February 14, 20160 found this helpful
thanks so much...this was very helpful. I took a straight pin and cleaned out the blocked nozzle then took an old toothbrush and scrubbed it all about.......and it is working..again thanks...
Add your voice! Click below to comment. ThriftyFun is powered by your wisdom!
In This Article
You are viewing the desktop version of this page: View Mobile Site
© 1997-2016 by Cumuli, Inc. All Rights Reserved. Published by ThriftyFun
generated on October 20, 2016 at 12:08:28 AM on 10.0.0.94 in 998 msecs. Use of this web site constitutes acceptance of ThriftyFun's Disclaimer
. If you have any problems or suggestions feel free to Contact Us