Using Masking Tape to Label Screws
When taking apart something that has a variety of screws, I use masking tape. Label the tape with what part the screws go to, then stick the screw right to the tape. No more lost screws or trying to figure out what screw goes where!
By Debi from Corona, CA
Add your voice! Click below to comment. ThriftyFun is powered by your wisdom!
Related Content(article continues below)
© 1997-2017 by Cumuli, Inc. All Rights Reserved. Published by ThriftyFun
generated on January 16, 2017 at 12:19:37 PM on 10.0.1.155 in 1 seconds. Use of this web site constitutes acceptance of ThriftyFun's Disclaimer
. If you have any problems or suggestions feel free to Contact Us