To Top

Label Your Cords to Prevent Pulling Out Wrong Ones

Behind my entertainment center you will find a variety of cords running to power bars. Pulling the wrong one when changing something can start a chain reaction of having to reset everything.


I use labels of any kind or masking tape to write big on it and label the end of the cord. I usually put the label about 3 inches before the power bar so I can read what it is I am searching for. It saves so many headaches and time undoing mistakes!

By Joyce from Benson, MN


Add your voice! Click below to comment. ThriftyFun is powered by your wisdom!

February 14, 20090 found this helpful

Good tip, and so sensible.

ReplyWas this helpful?Helpful? Yes

Add your voice! Click below to comment. ThriftyFun is powered by your wisdom!

Related Content
In This Guide
labeled cords
Labeling Electronic Cords
Organizing Clutter ControlFebruary 13, 2009
Chicken Pulling Out Its Feathers
An electrical cord plugged into an outlet.
Finding Replacement Cords for Electronics
TV with hidden cords.
Hiding Electric Cords
Storing Extension Cords
Storing Extension Cords
Easter Ideas!
St. Patrick's Ideas!
Ask a Question
Share a Post
© 1997-2017 by Cumuli, Inc. All Rights Reserved. Published by . Page generated on March 17, 2017 at 10:14:19 PM on in 2 seconds. Use of this web site constitutes acceptance of ThriftyFun's Disclaimer and Privacy Policy. If you have any problems or suggestions feel free to Contact Us.
Loading Something Awesome!