DianaHM
Silver Answer Medal for All Time! 440 Answers 
From a soda can you can quickly and easily make a candle holder. And if you use wire from an old transformer, then this candle holder will cost you absolutely nothing.
Total Time: 20 Minutes
Yield: Candle holder with a diameter of about 2.6 inches
Supplies:
- drink can
- scissors for metal
- hammer
- awl
- protractor
- wire 0.8 mm diameter, I used copper wire from an old transformer
- pliers and wire cutters
- mat
Steps:
- Cut off the bottom of the drink can. Trim the edges.
- Use the corner of the hammer to hit in the center to push the aluminum inward. Make sure the candle holder is stable.
- Using a protractor and an awl, make 8 holes at the edges at the same distance (15 degrees).
- Thread the wire through the holes, winding in one direction. Twist the ends at the back of the candle holder.
- Thread the wire through the holes, winding in the opposite direction. Twist the ends at the back of the candle holder.
Add your voice! Click below to comment. ThriftyFun is powered by your wisdom!
