social

Craftsman Riding Mower Won't Start?

I have a Craftsman automatic 42" cut Koehler Pro 16.5 ohm, (S.s# 052000b007775/ Mod # 917.271141). I can not get it to start! I replaced the battery, spark plug, air filter, oil, and oil filter. When I turn the key nothing happens except a faint click. The mower worked last summer without any problems. I'm not quite sure what to look into next. The starter?

Advertisement

Add your voice! Click below to answer. ThriftyFun is powered by your wisdom!

 
August 5, 20150 found this helpful
Best Answer

Did you check your carburetor? I had the same problem with my push mower and did all the things you did but it still would not start and a friend told me to check the carburetor. Took it apart and saw a little sludge on the bottom that was plugging the hole in the carburetor screw. Cleaned it out, put it back together and it started right up. The thing I learned from this was to run the mower until there is no more gas for it to run after the season is over. And to always put gas stabilizer additive in new gas to also help prevent this problem.

 
September 9, 20190 found this helpful

Seriously?! He said he heard a faint click. Why would you even mention the carb??? Obviously, needs a solenoid (or battery is toast)!

Advertisement

Carburetor has absolutely nothing to do with "a faint click"! And yes, I realize this is an ancient thread...

 

Bronze Feedback Medal for All Time! 119 Feedbacks
August 4, 20150 found this helpful

Have you looked at the mower's switch that the key goes into, perhaps it is the starter?

 
August 5, 20150 found this helpful

Second thought.....does the mower have a battery? is it charged if it does. And if that is ok...then it must be the starter.

 
Anonymous
November 16, 20150 found this helpful

Put new starter in

 
Anonymous
April 1, 20160 found this helpful

The problem is the solenoid is bad or something is not connect properly. Try charging your battery but it should have been already charged because you said you bought a new one

 
Anonymous
May 14, 20160 found this helpful

My tractor would not crank even with a fully charged battery. I took out the spark plug and it cranked great. A friend suggested that the cylinder was "loading up" with fuel from carburetor. I put in an in line fuel shut off (about $10.00) and it solved the problem.

Advertisement

Now, I think I have a problem with the seat safety switch. When I jump direct from battery to the starter the engine starts right up!! How do I disable the seat switch?

 
Anonymous
May 27, 20160 found this helpful

Flot needle and seat stuck in carburetor due to gas drying up in carb. after seting up for long time. remove bowel, free flote & needle valv. replace bowel.

 
June 13, 20160 found this helpful

use jump cables from battery to starter black on neg.battery then black to any good ground on mower red to pos.on battery and red to starter if it cranks its your selonid

 
January 2, 20170 found this helpful

jump the solenoid with a screwdriver and see what happens. If it turns it's your solenoid that is shot

 
Advertisement

Add your voice! Click below to answer. ThriftyFun is powered by your wisdom!

 
In This Page
Categories
Home and Garden Repair Machines Lawn MowersAugust 3, 2015
Pages
More
💘
Valentine's Ideas!
🍀
St. Patrick's Ideas!
🎂
Birthday Ideas!
Facebook
Pinterest
YouTube
Instagram
Categories
Better LivingBudget & FinanceBusiness and LegalComputersConsumer AdviceCoronavirusCraftsEducationEntertainmentFood and RecipesHealth & BeautyHolidays and PartiesHome and GardenMake Your OwnOrganizingParentingPetsPhotosTravel and RecreationWeddings
Published by ThriftyFun.
Desktop Page | View Mobile
Disclaimer | Privacy Policy | Contact Us
Generated 2024-01-23 05:09:12 in 1 secs. ⛅️️
© 1997-2024 by Cumuli, Inc. All Rights Reserved.
https://www.thriftyfun.com/Craftsman-Riding-Mower-Wont-Start-11.html