Could I use weldbond mixed with glitter and go over the small pin holes on top of my freshly cement stepping stone? And then, seal it with grout sealer for outdoors?
Add your voice! Click below to answer. ThriftyFun is powered by your wisdom!
Instructions from Weldbond:
Use as a Bonding Agent.
Bond new concrete to old. Repair cracked or flaking surfaces. Trowel out to a featheredge.
Step 1: If required, seal the surface. (using 5 parts water and 1 part Weldbond).
Allow 1 hour to dry.
Step 2: Apply a coat of 3 parts Weldbond and 1 part water.
While this is still tacky, pour wet cement mixture on top.
If you need more specific instructions you can contact them here:
I have used E-6000 to repair broken pieces and it worked okay.
Just use it as if you were repairing a plate; clean the area before starting no matter what you use.
Be sure you do not use anything that will make the stones slick/slippery.
I think that would work well.
Some good info here: www.weldbond.com/
You might also contact them to ask about using it on your stepping stones.
Add your voice! Click below to answer. ThriftyFun is powered by your wisdom!
