I have a pre-lit tree that is about 3 or 4 years old. I put it together and plugged it in. None of the lights work? How do I fix it?
By Liz
Add your voice! Click below to answer. ThriftyFun is powered by your wisdom!
My solution would be to buy a couple 100 count strings of cheap lights and put them on the tree.
I'm still searching for a solution to the same problem you are facing. From what I found so far, there can be 3 causes for this issue:
1. Plugs in each section of the tree are not connected in the correct sequence.
2. Each plug in the tree has a small fuse compartment which you may have never noticed before. If fuse is black or looks burned, it needs to be replaced.
3. It could be a bad light bulb in a section of the tree. One bad light bulb can cause a whole section to not light up. To detect the bad bulb, you need something like Lightkeeper Pro which also comes with spare light bulbs. Sold on Amazon, Target or Home Depot.
For mine it's number 3. But I can't get the same light bulbs again. The ones that comes with the lightkeeper pro are not the same either. Mine are clear w. a green base. Any advise?
Add your voice! Click below to answer. ThriftyFun is powered by your wisdom!
