Here are the questions asked by community members. Read on to see the answers provided by the ThriftyFun community.
My ice maker is making ice fine. The shut off arm also seems to be doing it's job. However, it will not dispense.
Try turning off the freezer when you have little food left and defrosting it. It may clear it up.
The ice maker in in my Kenmore refrigerator did work. I put it back together. It goes though its cycles, but the feeler arm does not drop back down.
Mine had similar issues, but my book said to reset the water filter. I reset it 3 times before it started working again.
My ice maker tray is never in correct position to receive the input of water. How do I reset the ice maker timer so that it will be in correct position to receive the water for ice making?
As it is, the water empties into the storage tray under the ice maker. My fridge is an older Kenmore, model 1067689313 (2 door, freezer on top).My ice maker just stopped doing anything. I pulled it out and opened it up. There is no damage or burnt/broken components. Nothing appears damaged at all. The water tube seems clear. I filled the little bowl with water and it froze, but did not dispense.
The light on the inside wall of the freezer gives no error messages. It is as if a fuse is blown, but I did not think these things had fuses. Is there a circuit board that might need to be replaced?No, there isn't a circuit board on the unit. If you're having issues of the try dumping ice, then you have a problem with the motor that operates the arm and try.
Our Kenmore side by side with factory installed ice maker is not making ice at all. Prior to this for some reason every once in a while we would have water spilled forming icicles, otherwise we would have ice. Now nothing happens, no ice or spilled water to form the icicles. Suggestions?
By J. Peterson
You can contact the manufacturer for possible help or request a service company recommendation.
Where you push against the bar to activate the ice maker, it started being hard to push and almost clicks when I push against it. It's a Kenmore Elite side by side. The happens whether you get ice or water.
By Tina A
Likely the switch mount is broken. Watch this video to fix it. youtu.be/
Ice freezes in the bin of my Kenmore two door refrigerator and when I push the dispenser it turns round and round, but because ice freezes in bottom of bin, no ice comes out.
I take it out and clean the frozen ice out, and it works for a few times, but it soon refreezes again.
By Carol S. from Aurora, CO
Sounds like the dispenser door flap is not closing all the way and the airflow that goes up into your bin changes the ice to a block.
Ice bin was full so I emptied it and now the ice maker isn't making any ice. Suggestions?
By Chris
When you put it back in, did you lower the wire bar that lets ice maker know bin is full?
Also, did you check to make sure the bin clicked into the correct position?
I have a 2008 Kenmore Coldspot refrigerator, model #106.58912801. The ice bin freezes up about every two days. The door chute assembly was replaced by a Sears tech approx. 2years ago. I have cleaned it out numerous times and inspected flapper assembly with a flashlight. (no light shows through) Also I have noticed that the middle pillar section between where the doors close around ice bin area appears very warm to the touch to me all the time. Any ideas? Thanks.
By Bob
The middle pillar is where the auto-defrost wires are located inside.
I installed a new ice maker and a new water valve and either one will work.
By Lavonne
My whirlpool fridge will not eject the ice from the tray. I have replaced with a new board, and it freezes ice but will not cut and eject.
The ice maker in a Kitchenaid refrigerator is not calling for water to the ice maker.
By Dave
Can only say that I had the same problem and the diagnosis was the very small spigot connecting to supply was at fault. It is under the sink.
I have a Kenmore Coldspot refrigerator that will not make ice or will not fill up. I tried the hairdryer, but didn't work.
By Keith
Is the release lever in the 'on' position? I ask only because I had the same problem once and it turned out I hadn't realized it was accidently pushed to the off position when cleaning - LOL.
My Kenmore Elite side by side ice bin is stuck. Not only that, it will not dispense ice anymore. It makes a grinding sound on the cube or crush setting. However, what I want to do is remove the bin entirely from the door and it is stuck. I have removed the ice, used the blow dryer, etc. and it is stuck even when pressing the side release. How do I get it out without breaking it?
By Tracy E
We have a side by side and the ice bin gets stuck due to ice melting and then freezing on the underside of the bin. Don't know why it happens, but we first empty the bin of all ice from the top of the bin. Then we place large beach towels around the floor under the freezer door and pour water through the top of the ice bin(you can try to catch the water through the dispenser on the outside of the door or at the base of the freezer door with a bowl or cups).
It takes a while of doing this to melt the ice that's blocking the ice dispenser. We can usually see big chunks of ice blocking the dispenser by taking a flashlight and looking up into the dispenser from the outside of the freezer door. Then after pouring the water through a couple times, we take a long sturdy plastic handle and try to break up the ice stuck in the dispenser(either through the ice bin downward or on the outside upwards through the dispenser while holding the flap back).
It's a real pain!
The icemaker and water dispenser on my Kenmore side by side refrigerator does not work with the new filter in place. They work fine when the filter is out.
By David B
My icemaker stopped working and the model # sticker was not on the icemaker. The refrigerator is model #363.9735756, serial #l30244063, what model do I need to replace this unit?
By Adolphus from Gray Court, SC
Check with your Sears appliance department or a Sears repair shop if you have one near. Also check the Sears repair site on the internet. Enter your model number and a parts list should come up.
Pat
I have a Kenmore refrigerator with a ice maker that was working fine. Then it started leaking water into the inside of the freezer unit from the ice maker. It drips water from the back of the ice maker all the time. This is making a mess in my freezer, how can I fix it?
By Rick B.
There is a rubber tube on the back of the fridge that feeds the ice maker. Pull it out of the fridge....you'll likely find its frozen solid. Thaw in a cup of hot water or use a hair dryer. This is usually caused by blocked or old water filter.
Our Kenmore ice maker tray has ice in it, but it won't release it and make more. The water spout is empty, should it have water in it waiting? Can I replace the ice maker myself? Kenmore Elite Model No. 106.52602100
By CMH
Usually ice sticks because of mineral buildup in the tray. Take the tray off and soak it overnight in vinegar. Repeat if needed until the inside of the tray feels smooth. Some people even spray Pam inside the trays and dump the first cubes.
How do I clean my ice maker in my Sears freezer so that it works?
By darlingbeth from Long Island, NY
Do you see a lot of lime buildup? If so soak some cotton balls with vinegar wait about an hour or so it'll come right off.Mine quits sometimes and I have to unplug my fridge and put a blow dryer on hot on it for a bit (where the water comes out and goes into trays) and it'll start back making ice again. Not sure if this will help but good luck.
I just purchased a new Kenmore Elite side by side 30 cu ft refrigerator freezer. I have water in the door, but the ice maker will not work. The water dispenser works. Sears hooked up the unit, but I had to wait 24 hours for ice to work, it is now 72 hours and still doesn't work. My old Kenmore made ice on the same connection. Help.
By Jack D.
I have a Kenmore top freezer fridge with ice maker. It still makes ice but not enough to cover bottom of the bin. Any suggestions?
By Jessica W
The ice gets stuck on top of the ice maker then water pours out and won't stop running.
By Patti
How do I turn the ice maker back on? There is a nice off button to push and I believe it is off. How do I turn it on? It is a Kenmore side by side bottom drawer. It is 2 years old.
By Jp
My Kenmore refrigerator is a side by side, model # 106.55649500. I replaced the broken ice maker. The new one makes ice fine, but when it refills with water it refills 2 times immediately. The first time the water tray is filled up OK. Then it turns on again and when it does the tray overflows. I've adjusted the screw on the side, but it doesn't help as the water simply turns on two times. Any ideas?
By Jackson
I have a Kenmore side by side. When using crushed ice we find small pieces of plastic in it.
By Mike
Why does the ice maker dispenser flap in the door stay open?
By Larry from Union City, TN
My Kenmore side by side model #106 (?) 9555312 makes cubes, but then ices up in the back on the left (yeah, where the water tube shoots in) about 1/2 way thru a totally full bin. Then the dispenser is unable to produce cubes thru the door because the (inner spring?) in unable to move because of it being frozen to the blockage. The water tube is clear, obviously. Why would it make cubes, then create a frozen block and tube is open?
By Annie
My water/crushed ice/cube ice dispenser suddenly stop working! I have Kenmore side-by side refrigerator, model 3639557720.
How can I repair it?
By George
My ice maker keeps freezing up and stops making ice. It's a fridge with the drawer freezer on the bottom, Kenmore model #106.72002010.
By Kirk
It keeps freezing up and then stops making ice. It's a fridge with the drawer freezer on the bottom, Kenmore model #106.72002010.
By Kirk
My ice maker works for a couple days then quits working entirely. It will make a few trays of ice before quitting.
By Greg M
The ice maker is making ice, but it won't dispense down to the dispenser. How can I fix that?
By Baovy
My side by side Kenmore ice machine quit today. After reading some of these answers, I found there was no blinking light on the right wall while holding down the flapper on the left wall. What does that tell me?
By Patricia
My Kenmore bottom freezer ice maker stopped making ice. This happened a year ago and was caused by the thermostat that regulates humidity. The coils were all iced up. That is not the problem this time. How do I get the gears to move, to sort of re-set the mechanism?
By shaneDn
It will make one batch of ice and dump and refill, but the arm will not go back down.
By HD
My Kenmore side by side is about 10 years old. It worked fine until I moved to another location. When I started it back up the water works fine and it dumped one tray of ice. I tried a new filter top right, but it pops back out. Any suggestions? I had a service tech look at it. He thought it was a bad filter so he sold me another filter, but same thing happened.
By vicki