Here are the questions asked by community members. Read on to see the answers provided by the ThriftyFun community.
I have a Craftsman remote control garage door opener. The are 4 remotes (one for each car + the keypad remote fastened to the outside of garage frame). All four stopped working on the same day.
I replaced the batteries and when I try to program my remote controls the circuit board does not accept any of the remotes. I installed two new boards, both with the same results. The direct wired push button inside the garage always works, but none of the remotes do. Can someone "zap" the remotes like a neighbor with a grudge to cancel them out? I have not replaced the remotes, but I think that should be my next step. It's kind of weird that all four remotes stop working on the same day and the new control boards offer no help.
By Troy
Turn off your router on your computer you might be getting noise thats interfearing with the programing.
My keyless pad on the outside of the garage wasn't working. I took it off the wall to check on it and now the hand held I keep in the car won't work. What can I do. I do feel like I need a new keyless pad.
By Judy S.
I have 2 doors and two working remotes. I bought a third remote and tried to program it.
It is programmed, but both doors work simultaneously; not separately. What am I doing wrong?
By Dave V
My garage door opener will work from upstairs in the house, but it will not work from outside.
By Joyce B
My remote has seemed at bit slow for the past month or so. I would shake it and it would work. Today it won't work at all. I replaced the battery, but still won't work. It is a Skylink and it came with the home I purchased 5 1/2 years ago.
By Nell D.
We have two openers and two doors. for the past year there are times when neither one will open with the remotes or the keypad. We push the buttons over and over. Sometimes it will eventually open and sometimes it won't. We are thinking some kind of electrical interference but how do we figure it out? The batteries have been changed in everything and reprogrammed.
By Terry D.
My garage door openers keep needing to be paired to the control. The keypad works fine. I replaced the batteries in both remotes. I can pair them and they work for about a week and then I have to pair them again. What could be causing this?
By Lisa
I recently had a garage door replaced. After they left, I found that the remote opener and Homelink on my car stopped working on the garage door next to it. The company says it is nothing to do with the installation. Coincidence? sabotage?
By Mike P from Portland, OR
I have followed the instructions in programming the remote. It works to open the door, but not to close the door. Help!
By Ben
I recently bought and installed a keypad garage door opener. It works fine, however my hand held now does not work. When I reprogram it, it renders the keypad useless. How can I program both to work?
By Dave B from Columbus, OH