social

Bent Gasket on a Chest Freezer?

I recently purchased a pre-owned chest freezer that is like new and freezes well. However, the owner had propped the lid open to prevent mildew and now the gasket/seal is bent in that place. I tested the seal by closing the lid on a sheet of paper and the gasket holds it tight, except in that spot. Since this is not a frost-free freezer, I'd like to ensure a tight seal. Is there anything I can do to fix this, without having to replace the entire gasket?

Advertisement

By Moogies from Double Oak, TX

Bent Gasket on a Chest Freezer
 

Add your voice! Click below to answer. ThriftyFun is powered by your wisdom!

 

Silver Feedback Medal for All Time! 290 Feedbacks
March 24, 20100 found this helpful

Cut a thin strip of a sponge and glue it in the section where the gasket/seal is bent. If the glue doesn't hold, still use a piece of sponge in that area where the seal isn't tight.

 
March 27, 20100 found this helpful

Did you try to heat the magnet with a hair dryer? The magnet should drop back in place. Louis

 

Add your voice! Click below to answer. ThriftyFun is powered by your wisdom!

 
In This Page
Next >︎
Categories
Home and Garden Repair Appliances FreezerMarch 24, 2010
Pages
More
👒
Mother's Day Ideas!
🌻
Gardening
🐛
Pest Control
Facebook
Pinterest
YouTube
Instagram
Categories
Better LivingBudget & FinanceBusiness and LegalComputersConsumer AdviceCoronavirusCraftsEducationEntertainmentFood and RecipesHealth & BeautyHolidays and PartiesHome and GardenMake Your OwnOrganizingParentingPetsPhotosTravel and RecreationWeddings
Published by ThriftyFun.
Desktop Page | View Mobile
Disclaimer | Privacy Policy | Contact Us
Generated 2024-04-08 14:16:06 in 2 secs. ⛅️️
© 1997-2024 by Cumuli, Inc. All Rights Reserved.
https://www.thriftyfun.com/tf88491204.tip.html