Halloween Button Bracelet

The Halloween button bracelet is a very simple project that can be done by adults and children. This project can be a very personal and special project because you can use new buttons or older buttons that may have been your mother's, aunt's, or grandmother's.


Approximate Time: 10 - 15 minutes


  • old, new, or used buttons
  • .8 or .1 mm jewelry beading elastic
  • Scotch tape or small clothespin
  • scissors


  1. Cut a piece of jewelry elastic 9 inches long. (7 inches is generally the standard size for an adult bracelet and this leaves 2 inches to tie the knot.)
  2. Then tape one end of the elastic to a desk or table and begin stringing your buttons onto the elastic starting with orange, then yellow, then white, and then black buttons. Repeat the process until your bracelet has been filled to 7 inches, leaving 2 inches to tie a knot.
  3. Carefully remove elastic from taped surface or unclip the clothespin and take both ends of elastic and tie first overhand and then reverse the tie and pull elastic snug and then tie another reverse tie and pull snug and trim off excess elastic leaving a quarter inch tail on both tails. You can tie another knot if you would like to secure your button bracelet even further.

By Beth from Fairfield, PA

Add your voice! Click below to comment. ThriftyFun is powered by your wisdom!

In This Page
Crafts HalloweenOctober 28, 2010
Birthday Ideas!
Back to School Ideas!
Ask a Question
Share a Post
Better LivingBudget & FinanceBusiness and LegalComputersConsumer AdviceCraftsEducationEntertainmentFood and RecipesHealth & BeautyHolidays and PartiesHome and GardenMake Your OwnOrganizingParentingPetsPhotosTravel and RecreationWeddings
Published by ThriftyFun.

Desktop Page | View Mobile

Disclaimer | Privacy Policy | Contact Us

© 1997-2019 by Cumuli, Inc. All Rights Reserved.

Generated 2019/09/06 03:25:24 in 1 secs. ⛅️️
Loading Something Awesome!