Make Tool Holster from Old Work Glove
If you'll cut the worn fingers off an old work glove and then add two slots to the back of what's left, you'll have a quick, recycled tool holster that you can slip right onto your belt and put into immediate use.
By fossil1955 from Cortez, CO
November 22, 20100 found this helpful
Good tip! Work gloves are usually much sturdier than manufactured tool-holders. And recycling/repurposing means one (or two) fewer items in the landfill.
Add your voice! Click below to comment. ThriftyFun is powered by your wisdom!
In This Article
You are viewing the desktop version of this page: View Mobile Site
© 1997-2016 by Cumuli, Inc. All Rights Reserved. Published by ThriftyFun
generated on October 24, 2016 at 11:49:36 AM on 10.0.1.236 in 2 seconds. Use of this web site constitutes acceptance of ThriftyFun's Disclaimer
. If you have any problems or suggestions feel free to Contact Us