Fireplace Mantle

RE: Fireplace Mantle If you have the right kind of tools, you can nail into anything, including brick, cement, etc. The question is, will your fasteners weaken the chimney? Another matter for concern is the possibility of creating a fire hazard. I think it should be ok to put the mantel up if you have a good flue liner. I suggest you hire a professional to check on that, and clean your flue if needed, because it will matter whenever the fireplace is next used, mantel or not. Further, the location and size of the mantel is important to prevent fire risk. The main thing is to be sure the combustible parts are far enough away from the fireplace for the distance they project into the room. I recommend that you consult a modern book or an expert, to find out the proper proportions of depth/distance for safety, and build your mantel within those tolerances. I suggest you don't just blow off this concern by saying you don't use the fireplace for fires. It is possible that you will think differently sometime in the future, or that someone else may want to use the fireplace. Be safe, and build it with the assumption that someone someday will make a fire in the fireplace. You might want to consider not just a mantel, but a decorative fireplace surround. Basically, this means you have up-and-down side pieces as well as the top piece across. There are several interesting decorative possibilities to this structure. The side pieces can help to support the top piece, but you will not avoid having to fasten the surround to the wall or chimney. You may find it is easier to get the mantel height right with these side pieces. When we hung ours, (a mantel, not a surround) we found we had to support it with temporary braces, so it would not slide down while we were nailing it. You should also pre-drill nail holes before you try to mount the mantel (or surround) -- it does not take nearly so long to fasten if you don't have to pound through the wood, too! We chose to use counter-sunk holes, the kind that have a small diameter hole all the way through the wood, and a larger diameter one part-way through. This means that after it is up, you can cover the nail heads with wood putty, sand, and then stain to match the wood, for an invisible fastening. - Rose B, mother of three, in NC Posted on 08/31/2001 | Report Spam or Abuse

Post Feedback: Login using the form on the top of the page to post feedback (if you are a registered user). If you have not yet registered, click here to do so. It's FREE!.