|
|
|
By Sheila (Guest Post)
01/04/2005
If you take the tip of a sharp knife or a very small screwdriver and push in the snap to make it smaller it usually works. Sometime they are bent out to large and just need to be dented in alittle
By
12/29/2004
Buy that sticky back velcro, cut pieces to fit around both sides of the snaps and stick on.
By (Guest Post)
12/28/2004
This is hard to describe, but what I used to do is take a hammer to the part of the snap the sticks up. I've found that by GENTLY tapping on the "pokey" part, you make the tip a bit wider, making it stay in the other part better. This needs to be done carefully, if you flatten it too much, it won't snap at all.
Like ThriftyFun on Facebook
