4th of July Scrap Fabric Garland

Gold Post Medal for All Time! 899 Posts

garland hanging outsideSince our daughter's birthday is on the 4th of July I wanted to make some fun decorations that I could reuse. I am tired of buying the flimsy, cheap decorations at the store that only last one year. So I made this awesome garland to hang outside!



prepared scraps


  1. Measure every 2 inches along selvage edge, marking with a pencil.
  2. measure out 2 inch strips
  3. Use scissors to snip fabric, just past the selvage.
  4. snip through selvage
  5. Tear fabric into strips, starting at the snipped marks. The first and last strip may need to be trimmed to be 2 inches for the full length.
  6. tear strips
  7. Cut the selvages off each strip, then cut each strip into 11 inch pieces. You should get 4 pieces from each strip.
  8. cut strips into pieces
    red scraps

  9. Tie a loop at the end of the twine to hang the finished garland from. Take a piece of fabric and fold it in half. Put it behind the twine, bringing the ends up and through the loop. Pull both ends until it is pulled tightly onto the twine.
  10. adding fabric scrap 1
    adding fabric scrap 2
    adding fabric scrap 3
  11. Repeat alternating colors, until the garland reaches the desired length. Mine is 12 ft. long!
  12. garland in progress

Add your voice! Click below to comment. ThriftyFun is powered by your wisdom!

In This Page
< Previous
Crafts Fourth of JulyJune 25, 2014
Halloween Ideas!
Thanksgiving Ideas!
Ask a Question
Share a Post
Better LivingBudget & FinanceBusiness and LegalComputersConsumer AdviceCoronavirusCraftsEducationEntertainmentFood and RecipesHealth & BeautyHolidays and PartiesHome and GardenMake Your OwnOrganizingParentingPetsPhotosTravel and RecreationWeddings
Published by ThriftyFun.
Desktop Page | View Mobile
Disclaimer | Privacy Policy | Contact Us
Generated 2022-10-19 21:59:11 in 1 secs. ⛅️️
© 1997-2022 by Cumuli, Inc. All Rights Reserved.