Share on ThriftyFunThis page contains the following solutions. Have something to add? Please share your solution!
Approximate Time: 10 minutes
Remove the Advair labels on both sides. This usually leaves adhesive behind, so remove it with a bit of Goof-Off or other solvent on a rag. Make sure it's clean and dry. Discard the rag in an outdoor trash can.
With your scissors, cut a small circle of felt to fit in the center circle of the lower Advair shell. A bit of Super Glue will place the felt there permanently. The felt is necessary, because the shells won't stick to each other, the circle rim prevents it.
While keeping in mind how you want the shells to look, apply more Super Glue to the top of the felt piece and the bottom of the other shell, inside the circle. Press them together the way you want, just know that once the shell touches the felt, it's more or less there for life!
Press down a bit, and you're done. You can weight it down if you like, but I haven't found that necessary. And you now have a new use for those discarded Advair Diskus shells. 7) Once it's dry, customize! You can glue more together for taller dolls. Or add a cushion, or paint. How about taking a simple square of fabric, adding beads to each corner, then draping it over the top ? Or add a discarded CD-Rom and make a table. It's up to you! Advair Diskus is a trademark of GlaxoSmithKline, and I am in no way affiliated with them. I just had to do something with those purple plastic pieces!
By Dorrie from Norman OK