3D Valentine Hearts

Silver Post Medal for All Time! 277 Posts
January 30, 2012

These 3D hearts can be made in many different sizes and colors to decorate with for Valentine's Day. I am assisting a group with decorations for an upcoming Valentine dinner and dance, and we plan to make these in different sizes to hang from the ceiling.


Approximate Time: about 10 minutes



  1. Lightly draw lines one inch part across the paper and cut into strips. Leave two strips the width of the paper. Cut two strips 1 1/2 inches shorter than the original width. Cut two more strips 1 1/2 inches shorter than the ones you just cut. My strips measured 8 1/2 inches, 7 inches, and 5 1/2 inches.
  2. Lay the strips out as shown: short, medium size, long and then long, medium size, and short.
  3. Red paper strips.

  4. Work from left to right and stack the strips. Align them and then staple at the bottom.
  5. Aligning paper strips.


  6. Pull the short outside strips out and down toward the stapled end.
  7. First heart made.

  8. Repeat with the remaining strips, holding in place as you.
  9. Second heart made.

  10. Finally, staple the strips together at the base and your heart is ready to hang.
  11. Finished hearts - 3.

    By Rachel's Mom from Wilkesboro, NC

    Comment Pin it! Was this helpful? 3
In This Page
Crafts Valentine's DayJanuary 26, 2017
Halloween Ideas!
Thanksgiving Ideas!
Ask a Question
Share a Post
Better LivingBudget & FinanceBusiness and LegalComputersConsumer AdviceCoronavirusCraftsEducationEntertainmentFood and RecipesHealth & BeautyHolidays and PartiesHome and GardenMake Your OwnOrganizingParentingPetsPhotosTravel and RecreationWeddings
Published by ThriftyFun.
Desktop Page | View Mobile
Disclaimer | Privacy Policy | Contact Us
Generated 2022-10-23 19:33:20 in 4 secs. ⛅️️
© 1997-2022 by Cumuli, Inc. All Rights Reserved.