Carpenter Bee Trap

Get a 4"x4" post wood post cut into a 12" to 20" long section. Lay wood on a work bench horizontally. You will drill the same diameter of a common water or soda bottle opening at about 2" from the end and side of the wood. A 1" hole is good to a depth of 3 inches. Then drill two 1/2" holes at a 45 degree angles to the hole on both sides of the wood. It should form an "A" meeting at top of big bottom hole. If all three holes meet inside, just screw, slide or push an ordinary beverage bottle's mouth into main hole.

Place the trap over a railing, stair step, fence, etc. Leave it until some dumb bee crawls into one of the slanting holes, and drops into the bottle mad as hell! A weathered 4x4 is best. Leave the trap in the rain, sun, snow, etc. so that the bees will be more easily fooled that it is a real nest hole.

Add your voice! Click below to comment. ThriftyFun is powered by your wisdom!

June 2, 20150 found this helpful

Here's a "dumb" question: Won't the dumb bees see all the dead bees and start avoiding the trap?

Reply Was this helpful? Yes
May 26, 20180 found this helpful

nope! hence "dumb" bee name

Reply Was this helpful? Yes

Add your voice! Click below to comment. ThriftyFun is powered by your wisdom!

Related Content
In This Guide
Home and Garden Pest Control Bees & WaspsMay 27, 2015
Summer Ideas!
Pest Control
Ask a Question
Share a Post
Better LivingBudget & FinanceBusiness and LegalComputersConsumer AdviceCraftsEducationEntertainmentFood and RecipesHealth & BeautyHolidays and PartiesHome and GardenMake Your OwnOrganizingParentingPetsPhotosTravel and RecreationWeddings
Published by ThriftyFun.

Desktop Page | View Mobile

Disclaimer | Privacy Policy | Contact Us

© 1997-2019 by Cumuli, Inc. All Rights Reserved.

Generated 2019/07/12 12:34:59 in 2 secs. ⛅️️
Loading Something Awesome!