DIY Earbuds Holder

Getting earbuds tangled up is not only annoying, but terrible for their lifespan. You can make this cute and convenient holder for your earbuds in less than 10 minutes. This is a great way to upcycle or make use of gift cards that have some sentimental value in them. I use these for storage purposes. I also use them for on-the-go times, popping them securely in my purse.
Advertisement

Total Time: 10 minutes

Yield: 1 holder

Supplies:

Steps:

  1. Cut 2 long, thin strips at one end of the card. Make sure they are wide enough so they don't cut into your wires.
  2. Cut two little triangles, squares, or circles at the end of the slits.
  3. Cut a slit on the opposite end of the card.
  4. Insert the buds into the two openings at the top. They should stay in place snuggly but not make any indentations. Wrap the cord around the body of the card, then pop the end into the bottom slit. Tuck the end of the wire into itself above.
  5. Advertisement

Add your voice! Click below to comment. ThriftyFun is powered by your wisdom!

June 22, 20200 found this helpful

This is great!

Reply Was this helpful? Yes
June 22, 20200 found this helpful

Thanks, Michelle!

Reply Was this helpful? Yes

Add your voice! Click below to comment. ThriftyFun is powered by your wisdom!

Advertisement

Categories
Crafts Recycled Crafts OtherJune 17, 2020
Pages
More
🐛
Pest Control
😎
Summer Ideas!
🌻
Gardening
🎆
Fourth of July Ideas!
😷
Coronavirus Tips
Facebook
Pinterest
YouTube
Instagram
Contests!
Newsletters
Ask a Question
Share a Post
Categories
Better LivingBudget & FinanceBusiness and LegalComputersConsumer AdviceCoronavirusCraftsEducationEntertainmentFood and RecipesHealth & BeautyHolidays and PartiesHome and GardenMake Your OwnOrganizingParentingPetsPhotosTravel and RecreationWeddings
Published by ThriftyFun.

Desktop Page | View Mobile

Disclaimer | Privacy Policy | Contact Us

© 1997-2020 by Cumuli, Inc. All Rights Reserved.

Generated 2020-06-28 09:54:41 in 2 secs. ⛅️️

OtherRecycled Crafts