Gift Card Earbuds Holder

attosa
Diamond Post Medal for All Time! 1,246 Posts

DIY Earbuds Holder - buds secured to card Getting earbuds tangled up is not only annoying, but terrible for their lifespan. You can make this cute and convenient holder for your earbuds in less than 10 minutes. This is a great way to upcycle or make use of gift cards that have some sentimental value in them. I use these for storage purposes. I also use them for on-the-go times, popping them securely in my purse.

Total Time: 10 minutes

Yield: 1 holder

Supplies:

1 plastic card no longer in use
scissors

Steps:

Cut 2 long, thin strips at one end of the card. Make sure they are wide enough so they don't cut into your wires.

DIY Earbuds Holder - two slits in one end of the gift card, cut at an angle

Cut two little triangles, squares, or circles at the end of the slits.

DIY Earbuds Holder - triangle shapes cut at the base of the slits

Cut a slit on the opposite end of the card.

DIY Earbuds Holder - notch at the opposite end in the center of the card

Insert the buds into the two openings at the top. They should stay in place snuggly but not make any indentations. Wrap the cord around the body of the card, then pop the end into the bottom slit. Tuck the end of the wire into itself above.