Raising Your Sinks (and Other Tips)
I want to say that this site is awesome! I don't know how to get more than one pic on at a time so I will do this in parts so you can see it all. I did 2 bathroom vanities and my kitchen.
- I started by cleaning with vinegar and then lightly sanding all my work.
- I raised up my sinks because I didn't want a "lip" around them that you get even using tape. This was done by unscrewing from underneath then using two 2 x 4s cut a little higher that the distance from the floor to the bottom of the sink and wedging them in. It didn't interfere with the plumbing at all and I could put the paint and sealer right under the sink.
- I used an oil based primer (Kiltz) after cleaning and lightly sanding.
- When it dried I put a water based coat of paint on the whole thing then took 3 colors plus metallic gold craft paints with a sea sponge cut into different sizes and started patting away.
- When I got what I wanted I used water based varethane for floors to seal it. I did 5 coats lightly sanding in between each application. It can be re-coated after 2 hours of drying time.
I waited a week before I sat anything on them but I don't think I would have had to. It says on the can that "normal walking" can be done after 3 days. Remember, you can put water based stuff over oil but you cannot put oil based over water. You will get bad results if you do.
The pics I have don't really show how pretty they actually are. They shine beautifully and I am using them like I would normal counters. My friends love them and want me to do theirs!
Add your voice! Click below to comment. ThriftyFun is powered by your wisdom!
Published by ThriftyFun.
© 1997-2021 by Cumuli, Inc. All Rights Reserved.