I have a Kenmore washing machine. It will fill with water, but then will not run through the cycles. When I disconnected the hoses the hot water screen was filled with black stuff.
Add your voice! Click below to answer. ThriftyFun is powered by your wisdom!
If the lid switch in your washing machine goes bad, the washer will think the lid is in the open position. This will cause the machine to not do anything after it fills with water. If the lid switch is bad, having the lid either open or closed will make no difference. If the washing machine has power, has filled with water, then stops, makes no noise, then the lid switch is most likely the part that needs replaced.
For more information, check out:
You may also have a timing problem, which is causing the machine to not advance to the next cycle.
My timer advances to completion, but machine does not wash drain or spin.
Is this a front loader or top loader? Did you clean the black stuff out and try again?
If a front loader, is it balanced?
Add your voice! Click below to answer. ThriftyFun is powered by your wisdom!
