Maytag Washer Won't Run?

I have a Maytag Maxima front loader. We kept on getting error codes for plugged drain so we cleaned out the hoses and took off the front panel and cleaned the lower filter which was pretty nasty. There were kids' socks, toys, and almost $5 in change, but we put it back together and tried to start a load and all it does is beep a few times in a metallic tone then shuts down. I believe it threw out a code of INT at one point since we put it back together.


Add your voice! Click below to answer. ThriftyFun is powered by your wisdom!

October 1, 20170 found this helpful

From product help

The cycle was paused or canceled. The washer may take 20 to 30 minutes to stop spinning and drain, and will display this error code during that time.

To remove the code, press pause or cancel button twice and the power button once.

If the code is still displayed, unplug the washer or disconnect the power for one minute.

Reply Was this helpful? Yes

Add your voice! Click below to answer. ThriftyFun is powered by your wisdom!


In These Pages
Home and Garden Repair Appliances Clothing WashersJanuary 9, 2016
Thanksgiving Ideas!
Christmas Ideas!
Coronavirus Tips
Ask a Question
Share a Post
Better LivingBudget & FinanceBusiness and LegalComputersConsumer AdviceCoronavirusCraftsEducationEntertainmentFood and RecipesHealth & BeautyHolidays and PartiesHome and GardenMake Your OwnOrganizingParentingPetsPhotosTravel and RecreationWeddings
Published by ThriftyFun.
Desktop Page | View Mobile
Disclaimer | Privacy Policy | Contact Us
Generated 2020-11-25 22:13:35 in 1 secs. ⛅️️
© 1997-2020 by Cumuli, Inc. All Rights Reserved.