Threading A Drawstring

Ever change your mind on what ribbon you would like to use or find that the tube you made for the drawstring is too small to run the safety pin through? Thread a large needle with your ribbon and run the eye of the needle through the hole you left, then through the tube. Push your needle eye first around the tube coming out in the hole where you started. It solves the seam folded the wrong way problem, also, as it will push through or work its way under much easier than a safety pin. This method sure saves me a lot of ripping and starting over.


By Ann Winberg from Loup City, NE

Add your voice! Click below to comment. ThriftyFun is powered by your wisdom!

October 25, 20180 found this helpful

Very smart idea. I'm going to remember this one. Thank you.

Reply Was this helpful? Yes

Add your voice! Click below to comment. ThriftyFun is powered by your wisdom!

Related Content
In This Guide
Crafts SewingJanuary 25, 2012
St. Patrick's Ideas!
Valentine's Ideas!
Ask a Question
Share a Post
Better LivingBudget & FinanceBusiness and LegalComputersConsumer AdviceCraftsEducationEntertainmentFood and RecipesHealth & BeautyHolidays and PartiesHome and GardenMake Your OwnOrganizingParentingPetsPhotosTravel and RecreationWeddings
Published by ThriftyFun.

Desktop Page | View Mobile

Disclaimer | Privacy Policy | Contact Us

© 1997-2019 by Cumuli, Inc. All Rights Reserved.

Generated 2019/01/03 15:10:15 in 1 secs. ⛅️️
Loading Something Awesome!