social

Handmade Wifi Signal Booster


Silver Post Medal for All Time! 254 Posts

finished booster with concave part facing cameraWith just a few supplies that you have laying around the house, you can make a signal booster for your wifi.

Advertisement

Supplies:

supplies
 

Steps:

  1. Carefully cut the top off an aluminum can.
  2. cutting top off can
     
    cutting top off can
     
  3. Then cut the can open down the side. Then cut off the bottom of the can, making a rectangle.
  4. cutting down side of can
     
    cutting off bottom
     
  5. Trim the edges of the can to remove any sharp bits.
  6. trimming edges
     
    additional edge trimming
     
    finished aluminum rectangle
     
  7. Place the can on a piece of cardboard creating a semicircle. Make sure each end of the can reaches the straight edge of the cardboard. Make a mark on the cardboard where each end hits.
  8. placing can in semicircle on cardboard
     
    marking ends of curved can
     
    Advertisement

  9. Using a ruler, mark the center in between the marks. Use the compass to make a semicircle as wide as the marks on the cardboard.
  10. finding center
     
    using compass
     
  11. Cut the semi circle out and use it as a template to make another semicircle of the same size.
  12. cutting out semicircle
     
    tracing second semicircle
     
    two matching cardboard parts
     
  13. Use a pen to make a hole in the center of each semicircle.
  14. finding center (top to bottom) of semicircle
     
    poking hole through cardboard
     
    finished cardboard parts
     
  15. Place one of the semicircles inside the curve of the aluminum can at one end and super glue in place. Hold in place until the glue is dry.
  16. gluing cardboard to can
     
    gluing cardboard to can
     
    Advertisement

  17. Repeat on the other side. You may want to cut off any excess card board that is sticking out.
  18. letting dry
     
    trimming off excess cardboard
     
    finished booster
     
  19. Place over your wifi antenna and point in the direction you want the wifi signal to go.
  20. booster installed on antenna with convex side facing forward
     

Add your voice! Click below to comment. ThriftyFun is powered by your wisdom!

 
January 15, 20150 found this helpful

Does the inside or outside of the can face the direction you want the signal to go?

 
August 15, 20180 found this helpful

The inside, it works like a tv dish

 

Add your voice! Click below to comment. ThriftyFun is powered by your wisdom!

 
In This Page
Categories
Make Your Own MiscellaneousNovember 5, 2014
Pages
More
🎂
Birthday Ideas!
💘
Valentine's Ideas!
🍀
St. Patrick's Ideas!
Facebook
Pinterest
YouTube
Instagram
Categories
Better LivingBudget & FinanceBusiness and LegalComputersConsumer AdviceCoronavirusCraftsEducationEntertainmentFood and RecipesHealth & BeautyHolidays and PartiesHome and GardenMake Your OwnOrganizingParentingPetsPhotosTravel and RecreationWeddings
Published by ThriftyFun.
Desktop Page | View Mobile
Disclaimer | Privacy Policy | Contact Us
Generated 2024-01-15 17:32:01 in 4 secs. ⛅️️
© 1997-2024 by Cumuli, Inc. All Rights Reserved.
https://www.thriftyfun.com/Handmade-Wifi-Signal-Booster-2.html