Rubber Band to Hold Ball of Twine

To hold string in place on a ball of twine, put a wide rubber band on over the end of the string. The ones that come on produce work well. When you need some string, just give it a pull and it will unwind under the rubber band. Cut off what you need and then place the ball of twine back where you keep it. The rubber band will hold it in place.


Add your voice! Click below to comment. ThriftyFun is powered by your wisdom!

December 14, 20160 found this helpful

A store twine in an empty coffee can. If it is a large ball of twine I use a large coffee can, a small ball of twine will fit nicely into a small plastic coffee can. Cut a hole in the top of the coffee can lid and insert the twine in the can put the top on the can and thread the twine through the hole so you can just roll that one out of the coffee can and leave a small piece at the top to retrieve it for the next project

Reply Was this helpful? Yes

Add your voice! Click below to comment. ThriftyFun is powered by your wisdom!

In This Page
Organizing CraftsSeptember 14, 2016
Valentine's Ideas!
St. Patrick's Ideas!
Ask a Question
Share a Post
Better LivingBudget & FinanceBusiness and LegalComputersConsumer AdviceCoronavirusCraftsEducationEntertainmentFood and RecipesHealth & BeautyHolidays and PartiesHome and GardenMake Your OwnOrganizingParentingPetsPhotosTravel and RecreationWeddings
Published by ThriftyFun.
Desktop Page | View Mobile
Disclaimer | Privacy Policy | Contact Us
Generated 2021-01-27 03:12:09 in 1 secs. ⛅️️
© 1997-2021 by Cumuli, Inc. All Rights Reserved.