Removing Hand Wheel on Sewing Machine

I inherited a Singer 427 sewing machine from my mother-in-law. In the case was the old motor belt which had been removed. I purchased a new one and I can't remove to plastic knob in the centre of the hand wheel.


I've managed to get the screw out, but it just won't budge. Any suggestions?

By Kate

Add your voice! Click below to answer. ThriftyFun is powered by your wisdom!

March 6, 20150 found this helpful
Best Answer

Hopefully by now you've taken this to a repair tech. Yes, the handwheel is supposed to be removed but it takes specialised knowledge to safely do so and restore the machine to working order.


The problem is that there is a little gear (and it sounds frozen) inside the middle knob that has to go back on the machine in the right position (and it's really hard to figure out if you're not trained!) or else the machine won't work. And the potentially frozen gear might be frozen because the bobbin gear further into the machine is 'dead'.

So a repair tech is the only person who should be taking apart a sewing machine. But good on you for having taken photos - did you take 'before' photos too? Having done so means you might be able to put the machine back together well enough to prevent 'basket case' charges - the extra money a repair tech charges to put back together a machine an untrained owner has taken apart to try a little DIY on.

Reply Was this helpful? Yes
August 28, 20170 found this helpful

I am trying to find that sweet spot to set the screw in the hand wheel so I can untitton the needle bar when I use the thread winder, which all does work. I just undid the screw in the handwheel to see what it looked like in my singer 3130 as compared to the one in my 15-99 or is it 15-91? the electric one. dumb me.

Reply Was this helpful? Yes
February 24, 20150 found this helpful

Are you sure it's supposed to come off? Rather than ruin it I would take it to a dealer.

Reply Was this helpful? Yes
November 16, 20170 found this helpful

I have a Singer 288 and its handwheel is very similar to yours. After removing the screw, I gave it a few taps on all sides with the screwdriver handle and gently pried it open with the screwdriver tip (it was a flat screwdriver) and it came off. There is a small metal object sitting inside that cap, so in case you attempt this again be sure to note which side is facing which direction, for when you put it back.


I wanted to remove the handwheel to change my belt, but I still haven't been able to do that yet. Seems as if it is somehow 'fixed' to the centre rotating shaft.

Reply Was this helpful? Yes

Add your voice! Click below to answer. ThriftyFun is powered by your wisdom!

Related Content
In This Guide
Home and Garden Repair Machines Sewing MachinesFebruary 23, 2015
Christmas Ideas!
New Years Ideas!
Ask a Question
Share a Post
Better LivingBudget & FinanceBusiness and LegalComputersConsumer AdviceCraftsEducationEntertainmentFood and RecipesHealth & BeautyHolidays and PartiesHome and GardenMake Your OwnOrganizingParentingPetsPhotosTravel and RecreationWeddings
Published by ThriftyFun.

Desktop Page | View Mobile

Disclaimer | Privacy Policy | Contact Us

© 1997-2018 by Cumuli, Inc. All Rights Reserved.

Generated 2018/12/10 15:37:03 in 1 secs. ⛅️️
Loading Something Awesome!