I have a top load Whirlpool washer gsw9650lw0. I have changed the transmission, clutch, the pump, and the coupler on this washer. When I changed it, it was working fine, but a month later it is not spinning the water out anymore. Is there something I am missing? Or people are loading it too full?
Add your voice! Click below to answer. ThriftyFun is powered by your wisdom!
Your drain hose may be kinked or there may be a clog in your drain line.
If you did the work yourself, something may not have been tighten correctly or it just came loose (not tight enough). Go back and check all of your work and tighten it back up.
You don't mention changing the timer. That was our issue on our machine. Sadly the fixes never worked for for years I had to manually move it into the spin cycle until the machine finally died.
Post back with an update.
It was the motor itself. It fully died. I thought about the timer and the electrical work on it. Thank you again!
Add your voice! Click below to answer. ThriftyFun is powered by your wisdom!
